The correct use of the wind box elastic sealing device for sinters and its effect on the working current of the driving motor are described in detail and the anti air leakage measures for the pallet body are introduced as well .

重点分析了烧结机主要漏风部位&风箱弹性密封装置的正确使用及其对驱动电机 工作 电流的影响，同时也介绍了台车本体的防漏风措施。

Working current of the motor is lowered down and efficiency increases .

同时也降低了同步电动机的 工作 电流，提高了工作效率。

The factors that have contribution to the external efficiency including the current spreading layers with different materials the thickness growth quality doping and working current have been analyzed based on the current spreading model .

利用经典电流扩展模型，分析了不同厚度、不同生长质量、不同掺杂浓度、不同 工作 电流对外量子效率的影响；并比较了两种不同材料的电流扩展层对外量子效率的影响。

It can measuer maxi phase starting current and maxi working current online .

可在线查找三相最大的起动电流和最大 运行 电流。

As there is big difference between standby current and working current working or standby mode can be judged by measuring the current flowing through appliances .

因为家电的 工作 电流和待机电流相差很大，所以可以通过测量流过家用电器的电流判断电器的工作或待机状态。

This paper deals with the calculations and design of a ballast variable resistor with working current as high as 1700 A and presents a set of generally applicable engineering calculation methods .

本文讨论 工作 电流高达1700A的镇定变阻器的计算和设计，给出普遍适用的工程计算方法。

The influence of the distance between both electrodes exposure time working current and developed time to the width differences of analytical line pair were discussed .

讨论了电极间距、曝光时间、 工作 电流和显影时间对分析线对宽度差之影响。

The power-consumption of the fuze is estimated by the working current voltage and working time of every circuit module of the fuze .

根据引信电路各模块的 工作 电流、电压及工作时间，估算整个系统的总功耗。

With this method the rheologic parameters of the slurry can be measured by measuring the working current and rotation speed of its electric motor .

理论上证明了可以通过测电动机 工作 电流和转速实现浆体流变参数的确定，从而为浆体流变参数的在线测量提供了可靠的理论依据；

The influence of the up-conversion emission intensity on the working current and doping concentration were detected . The multi-photon processes of the red and green emissions were analyzed .

我们还研究了不同激发 电流和掺杂浓度对上转换发光强度的影响，分析了实现红光和绿光发射的多光子过程。

Ionospheric loss of high frequency radio wave propagated in the ionospheric regions On amplitude and piecewise attenuation method of working current in ship ′ s magnetic treatment

电离层对高频电波吸收衰减的影响研究舰船磁性处理中的 电流幅值与 消磁 电流分段衰减方法

In order to guarantee the machining efficiency and accuracy the working current setting and feed motion control of short electric arc NC machine should be compensated and adjusted dynamically according to operation status and electrode dissipation .

短电弧机床加工过程中的 加工 电流设定和位置进给控制，必须根据其工作方式和刀具电极损耗情况进行动态的补偿调整，才能更好地保证被加工工件的加工效率和加工精度。

Max allowable continuous working current

最大允许连续 工作 电流

The temperature of Argon arc plasma at each working current is experimentally determined under conditions of local thermodynamic eguilibrium .

通过实验，诊断出局部热力学平衡状态下各 工作 电流的氩弧等离子体温度。

The working current is regulated with the step panel of maximum value for multi-valued inductance box .

多示值电感箱使用时，按示值最大的步进盘来限制 工作 电流。

Ught power can be controller by adjusting the laser 's working current .

通过调节激光器 工作 电流实现输出光功率控制。

Analysis was made to use conditions of4 kinds of categories the rated working current of AC-4 should be found out from actual load start current .

分析了4种使用类别下的使用情况，从实际负载起动电流去探求AC-4的额定 工作 电流。

Introduction was made to the bus-bar of medium-voltage switchgear for in addition to meet rated voltage working current the standard requirements of temperature rise and voltage down losses etc.

介绍了中压开关设备的母线除应满足额定电压、 工作 电流、温升、电压降损失等标准要求外，还应满足电流分布均匀、机械强度高、散热良好等条件。

On amplitude and piecewise attenuation method of working current in ship ′ s magnetic treatment

舰船磁性处理中的 电流幅值与 消磁 电流分段衰减方法

The utility model can reduce working current and leakage current increase working voltage and control capacitive discharge time .

利用本实用新型，可以减少 工作 电流及漏电流，增加工作电压，控制电容放电时间。

On working The equipment could display working current and temperature .

该可靠性评估系统可实时显示 工作 电流及工作温度值。

When the working current goes down from the rated value the electrode drops faster and faster .

工作 电流从额定值逐渐下调时，电极温度逐渐降低，且下降趋势加快。

Considering the magnetic coupling between the windings the harmonic components of working current are analyzed and the formulae for computing the harmonic current factor are derived using Fourier Method .

在考虑了绕组之间耦合的情况下，应用傅立叶级数分解方法对 工作绕组 电流的谐波含量进行了分析，推导了谐波因数的计算公式。

The calculation results show that the model can describe hysteresis characteristics under arbitrary pre-tightening force and maximum working current well .

计算结果表明该模型能很好地描述在任意预紧力和最大 工作 电流等工作条件下的磁滞特性。

The working current of the emissive probe and the ratio of input to output voltage of the capacity probe .

本文对发射探针的电子发射性能、 工作 电流、电容探针的输入、输出电压关系进行了标定实验。

By means of summarizing and comparing the method and result of both the experiment and numerical simulation the influence of thermoelectric coefficient ventilation capacity and working current on the performance of the prototype was analyzed .

通过对实验和数值模拟结果方法的总结和比较，分析了热电系数、风量、 工作 电流等不同参数对空调样机性能的影响。

The thermometric error of thermal resistor effected by working current

工作 电流对热敏电阻测温的影响

Parameters of the process such as working current density moving speed of cathode scanning times of cathode flowrate of electrolyte etc.

研究了 工作 电流密度、阴极移动速度、扫描次数、电解液流速等工艺参量对加工质量及效率的影响，获得了较优的工艺参数；

Results show that working current of target plays an important role in DLC film deposition .

结果表明，靶 工作 电流对DLC膜的沉积有重要的影响。