Also in this paper weldability and possible weld defects in TC4 titanium alloy are .

阐述了某型号 TC4钛合金壳体的结构特点和对手工氩弧焊焊缝的技术 要求。

This paper studies the effect of zinc and shielding gas type on Laser weldability of zinc-coated steels .

本文研究了锌对镀锌板激光 焊接 性影响，以及不同保护气体对镀锌板 焊接 性的影响。

The weldability of D6AC ultra high strength steel is analyzed and the fundamental of tandem sequence submerged arc welding with thin wire is introduced .

分析了D6AC超高强钢的 焊接 性，采用细丝双弧焊接方法，进行D6AC超高强钢的双弧焊接工艺试验研究。

This paper based on structure of axle case of three parts and the analysis of its weldability confirms welding technology for the girth welds of axle case in order to keep its weld quality .

文章分析了环形加热炉的现状，从炉子结构、 供热 分配、 烧嘴选择、 耐火 材料选择和环缝的确定等方面探讨了大型环形加热炉的最优设计方案。

With the rapid development of steel framed buildings the steel plates for buildings must possess higher performances of strength toughness yield ratio and weldability etc.

随钢结构建筑的迅猛发展，对建筑用钢板的强韧度、屈强比、 焊接 性等提出了更高的要求。

The results show that the high strength fine grain steel plate has good weldability and satisfactory post-weld ductility .

对高强度细晶粒钢板的 焊接 性能也进行 试验 和 分析，试验结果表明该钢板的 焊接 性能良好，焊后的韧性令人满意。

But the metallurgical structure and properties of this steel are sensitive to its chemical com-position and heat treatment . Thus its weldability and cold machinability are relatively poor .

但该类钢组织与性能对化学成分和热处理制度十分敏感， 焊接 性能和冷加工性较差。

Furthermore it is shown the cold weldability between the various combination of different types of metal .

并进一步说明了各种不同组配异种金属间的冷 压 焊接 性。

The weldability of high strength steel for railway vehicle produced by Baosteel was studied .

研究了宝钢高强度铁道车辆用钢的 焊接 性。

The previous investigations reveal that the ultrasonic weldability of aluminum alloy and magnesium alloy can be improved by adhesion of alcohol and halogen surface treatment respectively .

既往的研究结果表明： 焊前用乙醇润湿铝合金表面可提高其超声波 焊接 性，而对于镁合金利通过卤化处理可以有效地提高其超声波 焊接 接头强度；

Meanwhile the flux-cored wires with larger WC particles have excellent weldability .

同时，采用大颗粒WC的药芯焊丝 焊接 工艺 性优异。

Steel is well known for its high strength good plasticity good toughness and weldability .

钢以其高强度、良好的塑性、韧性和 焊接 性而著称。

Description : - Special wear resistant manganese steel featuring high toughness and excellent weldability .

说明：-特别耐磨锰钢，具有高韧性和优良的 可 焊 性。

The weldability of X80 pipeline steel was analyzed and its preheating temperature was determined .

针对 X80管线钢进行了 焊接 性分析，确定其预热温度。

Research into weldability of A New Generation of Blast Furnace Shell Steel LK 490

新一代炉壳钢 LK490埋 弧焊 性能研究

Pipeline Steel Carbon Content and Ceq Relation to Weldability

管线钢的碳含量和碳当量与 焊接 性的关系

This article conducts a research on the weldability of crystal diode lead wire luminous electrotinning .

本文对晶体二极管引线光亮电镀锡的 可 焊 性进行了研究。

Research on the Obdurability and Weldability of Al-Mg series Alloys

铝镁系合金强韧性能及 焊接 性能研究

Based on the analysis of the weldability of T91 steel and combining the practical experience of power plant the welding technology of T91 and high-temperature superheater header was put forward .

在分析T91钢 焊接 性的基础上，结合电厂实践经验，提出了将T91管材直接与联箱焊接的工艺措施。

Weldability test on X80 steel newly produced in WISCO was carried out .

针对武钢新近开发的高性能管线钢 X80钢进行了 焊接 性能研究。

The welding metallurgical characteristics and weldability of duplex ferritic-austenitic stainless steels were studied in this paper .

本文就铁素体-奥氏体双相不锈钢的焊接冶金特性和 焊接 性进行了研究。

Preparation of Ti-Si Eutectic Brazes and its Weldability to SiC

Ti-Si共晶钎料的制备及其对SiC陶瓷 可 焊 性

The weldability of high strength atmospheric corrosion resistance shape steel research

高强度耐大气腐蚀 乙字钢 焊接 性能研究

Analysis is carried out on weldability .

对 可 焊 性进行了分析；

The weldability of the 2205 duplex stainless steel were investigated and the key welding technique was introduced .

对2205双相不锈钢的 焊接 性能进行了研究分析，对材料的焊接技术关键进行了介绍。

The weldability of TCS corrosion resistant stainless steel for railway wagon was investigated by cold cracking sensitivity test HAZ maximum hardness test and varestraint test .

通过冷裂敏感性试验、焊接热影响区最高硬度试验及可调拘束试验，对新型铁路车辆用TCS耐蚀钢的 焊接 性进行了深入系统分析。

Inquiry Expert System of Stainless Steels ' Weldability and Welding Process

不锈钢 焊接 性及焊接工艺查询专家系统

This article introduces the structure of auto lamp and analyzes the weldability of its composition .

分析车灯的结构和组成 材料 的 焊接 性；阐述 精密 电阻 点焊的基本原理；

In this paper we studied and tested weldability of the new type high-manganesesteel .

对新型高锰钢的 焊接 性进行了试验研究。

Material of valve body shall be forged or cast steel and provide sufficient weldability .

阀体材料应是锻钢或铸钢并应有充分的 可 焊 性。