Design and Practice of the Winding Rope Fleet Angle of a Double Drum Winder for a Vertical Shaft

竖井双 卷筒提升机 钢丝绳偏角设计与实践

PLC automation transform of single winding drum hoist

单 滚筒提升机PLC自动化改造

Influence of the position of round board bearing wheel of a winding drum hoist on drum shell stresses

缠绕 式提升机圆板支轮位置对筒壳应力的影响

The Analysis and Solutions of the Cause of the Mine Winding Hoist Machine Drum 's Crack

矿井 缠绕式提升机 滚筒裂纹原因分析与防范措施

Dynamics Simulation of the Hoisting Cable of Single Cable Winding Hoisting Device Drop Coefficient of Pulling Force for the Multiple Coat Steel Cable Twined on the Drum

单绳 缠绕式提升机钢丝绳动力学仿真研究钢丝绳多层缠绕拉力降低系数& 缠绕系数

Analyzed the relationship of parameters of complete cold winding drum 、 curing pressure 、 precision of finished product 、 steel plate size and the winding-up equipment .

分析了整体冷 卷 鼓 体参数、硫化压力、制品精度、钢板规格及卷制设备能力间的关系。

A design method is mainly discussed for the cone drum curve of roving fr-ame which is proved to be only related to roving winding diameter and the va-riation regularities of speed differential ratio of the cone drum .

本文讨论了粗纱机铁炮曲线的设计方法，指出铁炮曲线仅与 卷绕直径和变速 铁炮的转速差异中的变化规律有关。

Ways of Fault Disposal of Principal Axis in KJ Sing - Cord Winding Hoister NEW CHECKING COMPUTATION METHOD FOR ROPES EXTRUSION AND FRICTION BETWEEN ROPES ON DRUM HOIST

KJ型单绳 缠绕式提升机主轴装置故障的处理 缠绕式提升机咬绳验算新方法

A measured method of equivalent mass to drum of winding system was introduced in this paper and established some functions of calculating equivalent mass to drum .

介绍了 提升系统变位质量的 实测方法，建立了变位质量计算公式。

Yarn hairiness forms in spinning process increases in winding process . The influence on yarn hairiness of grooved drum material and surface condition in 1332M cone winding machine was researched to control the increasing of yarn hairiness .

纱线毛羽形成于细纱工序，增长于 络筒工序，为控制纱线毛羽的增长，研究了1332M型络筒机的槽 筒材质和表面状态对纱线毛羽的影响。

The utility model relates to a metal wire drawing winding drum .

本实用新型是一种用于拉制金属丝 机械 的 卷筒。

The concrete measures such as adjusting radial winding density assuring the starting position of cone drum belt configuring tension exchange gear reasonably to adjust the roving tension were proposed .

并提出同时应采取调整轴向 卷绕密度、确定锥 轮皮带起始位置、正确配置张力变换齿轮等具体措施直接对粗纱张力进行工艺调整。