Aerodynamic Analysis on a Wind-Mill Generator of Horizontal Shaft Type

水平轴 风力发电机气动分析

This paper gives a brief description of the water-pumping wind-mill FT-2.5 involving considerations in its design and wind tunnel testing .

本文概述了 FT&2.5 风力提水机组的设计特点和风洞试验结果。

Every main blade has a small blade in its leading edge which leads to an improvement in the operation condition of the wind-mill at large angle of attack that is to say an increase in the starting moment of wind-mill .

每片主叶片前 上方 配置一 小翼，改善了叶片在大迎角情况下的工作条件，增大了风轮的起动力矩。

Design of yaw control system of MW wind-mill generators

MW级 风力发电机组偏航控制系统的设计

The prediction of flow rate and by-pass ratio of turbofan engine at wind-mill condition

混合 排气的涡轮风扇发动机在 风车状态下的流量及 内外涵 流量分配的计算

Due to the different structure and parameters the properties of model rotor are different . The structure of rotor must be chosen according to the property requirements of the working machine which matches with the wind-mill . In this way the optimum matching performance can be obtained .

由于不同结构和参数的 风轮模型具有不同的性能，因此，必须根据与 风力机配套作业机具的性能要求选择 风轮结构，以求取得最佳的匹配特性。