torsional strength

抗扭强度

  • Analysis of Torsional Strength in Large Container Ship

    大型集装箱船 扭转 强度分析

  • Design of a Test Rig for Static Torsional Strength with Electro-hydraulic Proportional Control

    电液比例控制的静 强度试验装置的设计

  • Based on the variable angle space truss theory a failure criterion for pure torsion is presented and a claculation method is established for ultimate pure torsional strength of reinforced concrete beams which considers the Mohr stress compatibility and the softened constitutive laws of concrete .

    根据变角空间桁架理论,在考虑莫尔应力谐调条件和混凝土软化基础上,提出了钢筋混凝土纯扭构件受扭破坏形态的判别准则,并建立了纯 极限 强度的计算方法。

  • The torsional strength and ultimate torsional strength of the warship is evaluated based on the thin-walled beam theory in this paper .

    本文基于薄壁梁理论对舰船 扭转 强度和极限扭转强度进行评估。

  • Methods The specimens of the five wires were tested and compared for their elastic modulus elastic limit tensile strength reverting angle torsional strength and fatigue strength .

    方法对上述5种临床常用正畸钢丝的弹性模量、弹性极限、回弹角、抗拉强度、 扭转 强度、疲劳强度等机械性能进行测试和比较。

  • Researches on mechanism and developing their strength calculation method for prestressed concrete structures are the foundation of complex torsional strength calculation .

    研究预应力混凝土构件 作用的机理和制定其强度的计算方法,是解决复合 强度计算的基础。

  • The thin walled beam theory and finite element theory were primary theory to study ship 's torsional strength .

    研究 扭转 强度的主要理论有薄壁梁理论和有限元理论。

  • Calculation of torsional strength of prestressed concrete members

    预应力混凝土构件 强度计算

  • Torsional strength and stiffness were measured .

    测定各组的 强度 刚度。

  • Moreover the paper presents a relatively simple and comprehensive theoretical method for torsional strength calculation .

    同时,提出了这类 舱口 船舶 扭转 强度的理论计算方法。

  • Torsional strength and structural reinforcement of ship with large opening

    大开口船舶 扭转 强度及结构加强方式研究

  • On line measurement of maximal torsional strength of micro level structure

    微米尺度结构最大 强度的在线测试和研究

  • The Calculation for Ultimate Pure Torsional Strength of Reinforced Concrete Beams

    钢筋混凝土构件纯 极限 强度计算

  • The torsional strength of the drill stem tool joint is generally lower than that of the pipe body thereof .

    钻杆工具接头的 强度普遍低于管体,为满足使用需要, 考虑选择非 API 扭矩接头。

  • Based on studies on torsional strength of reinforced concrete members and test results of prestressed members formulae of ultimate torque for members with centrical prestressing force under normal conditions are proposed .

    根据预应力混凝土构件的 试验结果,在钢筋混凝土构件 性能研究成果的基础上,提出了中心预加应力在常用预应力值条件下的极限扭矩计算公式。

  • The fibers orientation angles ' effect to the torsional strength and torsional rigidity is analyzed in this paper by finite element software ANSYS and Tsai-Wu stress criterion .

    文中采用有限元软件ANSYS及Tsai-Wu张量准则分析了不同的铺层角度对轴的 扭转 强度和扭转刚度的影响。

  • Torsional strength analysis of powered support

    关于液压支架的 扭转 强度分析的探讨

  • The analysis of torsional strength of ship hull

    船体 扭转 强度分析

  • The Effect of Reinforcement Strength on Torsional Strength of Prestressed Concrete Beams

    配筋强度对预应力混凝土构件 强度的影响

  • Establish the finite element model of the ship and analyze the torsional strength and ultimate torsional strength of the cabin by finite element method . 4 .

    建立有限元模型,对舱段进行 扭转 强度以及极限扭转强度的有限元分析。

  • Serial Multilevel Substructuring Method for Torsional Strength of Integrated Barge

    分节驳 扭转 强度的串联多级子结构分析及模型试验研究

  • The torsional strength of the notch of spheroidal graphite ( SG ) cast iron by continuous casting was tested .

    研究了一种用水平连铸技术生产的球墨铸铁型材的 扭转 强度和缺口 扭转强度。

  • When transmission shaft is working it mainly bears torque . So the carbon fiber tube must have sufficient torsional strength and torsional rigidity .

    传动轴工作时主要承受扭矩,所以碳纤维管要有足够的 扭转 强度和扭转刚度。

  • The principle of prestressed concrete in pure torsion is investigated by using the space truss theory with variable inclination considering softening of concrete and introducing the prestress degree into the calculation puts forward a new theoretical method for ultimate torsional strength .

    研究预应力混凝土受纯扭作用时的机理,运用变角空间桁架原理,考虑混凝土的软化效应,并把预应力度引入到计算中,提出了新的 强度计算公式。

  • The Model Torsional Strength Tests for a Wide Hatch Barge

    大舱口驳船的 扭转 强度模型试验研究