temperature saturation

[ˈtɛmpərəˌtʃʊr ˌsætʃəˈreʃən][ˈtempəritʃə ˌsætʃəˈreɪʃən]

温度饱和

  • Indicating the temperature when the saturation water vapor in the air reaches the saturation state and generates liquid water on the plane surface .

    是指空气中 饱和水汽达到饱和状态并在平面表面产生纯液态水时的 温度

  • The Curie temperature and saturation magnetization of manganese-zinc ferrite were measured by using the electric bridge method induced method and vibrating sample magnetometer ( VCM ) .

    分别用电桥法、感应法和振动样品磁强计对锰锌铁氧体的居里 温度 饱和磁化强度进行了测试。

  • Study is made on borehole dissolving rate simulation tests known the borehole expand rate and size the equation of dissolving rate is given with the relationships between different temperature and different saturation its corresponding equation is as following . 7 .

    进行了盐岩井眼溶解速率模拟试验研究,掌握了井眼扩径速率及其尺寸,建立了不同 温度 ,泥浆含盐 饱和度与盐岩井眼溶解速率之间的相关关系,并得到了相关关系方程。

  • PC foams were prepared by a foaming simulator at different processing conditions of foaming temperature gas saturation pressure .

    采用自制的微孔发泡模拟机研究了 温度和压力以及气体 饱和时间对微孔聚碳酸酯(PC)泡孔结构的影响。

  • The change of extracellular environment ( pH temperature saturation of O2 ) .

    细胞外环境(pH、 温度、氧 浓度)的改变等。

  • The influence of temperature iron saturation and pH on antibacterial activity was studied .

    研究了铁 饱和度、pH、 温度和阳离子对转铁蛋白抑菌性能的影响。

  • The most important physical process to form fog drop is by falling the temperature to the saturation point .

    降温是达到 饱和形成雾滴的最主要、最重要的物理过程,在自然界中的霾滴通过吸湿过程增长成雾滴几乎不可能。

  • Influences of temperature and saturation states on the precipitation rate of calcium carbonates in seawater ⅰ . Mg-calcite

    温度和过 饱和度对海水中碳酸钙沉淀速率的影响Ⅰ.镁方解石

  • The effects of foaming temperature saturation pressure and shear rate on the cell morphology of foamed PLA in microcellular foaming process of supercritical CO2 / PLA were investigated .

    研究了超临界CO2/PLA微孔发泡过程中,发泡 温度饱和压力、剪切速率对聚合物PLA泡孔形态的影响。

  • The Curie 's temperature Tc and saturation magnetization decreased obviously by Sr substituted with Cu or Ag and Sr2 + vacancy in the samples while the initial susceptibility is increased .

    通过用Cu或Ag部分替代Sr和少量Sr空位,使样品的居里 温度 饱和磁化强度比替代前的La(0.67)Sr(0.33)MnO3材料显著降低,而起始磁化率反而增加。

  • The regular changes on pressure field temperature field and saturation field of horizontal wells are also presented .

    总结了水平井的压力场、 温度场和 饱和度场的变化规律。

  • In the soil around a horizontal buried pipe temperature 、 water saturation and pressure change in lateral migration is not very significant ; On the contrary on the vertical gradient temperature 、 water saturation and pressure change is significant .

    在地埋管周围土壤水平方向, 温度、水 饱和度和压力在横向迁移的变化不是很显著;相反,在纵向梯度上,温度、水饱和度和压力变化较为显著。

  • A typical example concerned with the transient heat and mass transfer process in unsaturated porous media around a buried pipe is presented which explains the defining of boundary conditions property data and the method to obtain the initial temperature and wet saturation values .

    以埋管周围砂土内的传热传质动态过程研究为例,给出了不同边界条件的描述,介绍了介质物性数据及初始 温度、含湿 饱和度等的确定方法。

  • Sandstone geophysical response and elastic modul vary laws with pressure temperature saturation liquid character in high pressure & high temperature are studied .

    通过大量实验室研究分析在地层 条件 (高温、高压)砂岩的地球物理特征及其弹性模量随压力、 温度饱和度、流体性质的变化规律。

  • Study on the Measurement Methods of Curie Temperature and Saturation Magnetization

    居里 温度 饱和磁化强度测量方法的研究

  • For storage mode of normal temperature and high pressure based on simulation calculation of release rate of liquefied ammonia the influence of pipe length pipe diameter storage state and storage temperature in saturation condition on two-phase release rate were analyzed .

    针对较危险的常温高压存储,通过模拟计算,分析了管道长度、管道直径、存储状态以及 饱和存储 温度对液氨两相质量泄漏速率的影响。