The Conditionality of the Stress Formula of the Tension or Compression Member

论 拉压 杆应力分析公式的条件性

An unbalanced layup has higher-strength laminations positioned on the tension side of the member and is typically used for simple-span beam applications .

非均衡复合材料铺层定位在组成的 张力一侧，具有较高的强度 分层，通常是应用于简单跨度梁；

For a groove welded tension member in3 / 4 in . plate what is the maximum size of fusion discontinuity permitted in astatically loaded member ?

对于3/4英寸板材的 受 拉 构件坡口焊缝，在承受静载荷时，熔合性缺陷允许的最大尺寸是多少？

The Flex E are manufactured in polyurethane with a semi-elastic tension member .

半弹性多楔带用半 弹性带 芯与聚氨酯制成。

In the method control equations for the crack resistance capacity of the normal section are established thus the area of prestressed steel tension member may be calculated .

该方法首先建立了 构件在正常使用极限 状态下的抗裂性能控制方程，并以此求解预应力 筋的面积；

Most members are designed to carry loads in tension and the member is slim the structure is bright and beautiful .

大部分杆件按受 拉 控制设计，从而实现了建筑要求 杆 件纤细、构通透、颖美观的目标。

The method quantitative analysed the influence of the surface subsidence and tension by means use of the wedge-shaped active foundation adjusted the foundation loop member and building the tested building can balance which is stable and be used after being repaired .

试图采用该观测方法定量地分析地表下沉和地表 拉伸对建筑物基础圈梁的影响，以便采用楔形活动基破对基础 圈梁进行调整，使建筑物达到新的平衡状态，确保建筑物的稳定性。

Study on optimal hybrid ratio of hybrid fiber composite tension member

混杂纤维复合材料 受 拉 构件的最优混杂比研究

A tension member may fail by plastic yielding .

拉伸 元件可能由于塑性屈伏而破坏。

In the ordinary way bonded reinforcement technology only suitable for reinforcing flexural & tension member that bearing static load .

粘钢加固技术一般只适用于加固承受静力作用的受弯及 受 拉 构件。

Megadyne belts for knitting machine drive are manufactured in Polyurethane with high wear resistance and high tensile steel & kevlar cords tension member .

圆筒针织机聚氨酯同步带耐用性强及不会容易磨损，分别有钢丝芯及线 芯。

Experimental Study of Axial Tension Member with the Prestressed Concrete Mandril

配置预应力混凝土芯棒的轴 拉 构件试验研究

The tension soon transmitted Itself to all the member of the crowd

这种 紧张 情绪很快感染了人群中所有的 人

An important practical engineering problem is the stress distribution produced at or near a hole in a tension member when the load is applied to the pin or rivet filling the hole .

通过销钉或铆钉传递载荷的 拉伸 构件，发生在销钉孔周或孔的附近的应力分布，在工程实际中是一个重要的问题。