By means of sticking the electric-resistance strain pieces on the transverse of the planetary gear we have done the dynamic test of contact tooth pair numbers of the involute planetary transmission with mi - nor tooth difference in which the internal gear is used as the output member .

我们采用在行星轮 端面贴电阻应变片的办法对内齿轮为输出构件的渐开线少齿差行星传动进行了接触齿对数的动态 实测。

The transverse phase shift from the microwave cavity was evaluated by the test results .

由 测试结果进一步估算了微波谐振腔引起的 横向腔相移。

The load transverse distribution coefficient of test is in coincidence with the calculating hypothesis .

本文所 测试的荷载 横向分布系数符合计算假定；

Objective To evaluate that the measures of the largest transverse diameter and ofaverage diameter affect the results of Mantoux test .

目的研究最大 横径和横竖平均径两种不同测量方法对皮内结素 试验反应结果的影响。

By treating the rock as the transverse isotropic elastic medium and using numerical test of the wave velocity function the property is theoretically validated .

基于 横观各向同性弹性介质的波速方程，还进一步通过具体 算 例对这一特征进行较好的理论分析。

Esophageal reconstruction with interposition of transverse colon was performed in 24 children from 1971 to 1992 . The results were evaluated from questionaire clinical interview barium swallowing manometric and radioisotopic test .

对1971年～1992年，采用 结肠重建食管术后的24例小儿，应用问卷、放射线检查、食管压力测定及肠胃返流指数 测定 方法进行了随访。

Calculation Method for the Diamond Resistant Rigidity of Bogies Further by means of finite element analysis technology the intensity and deformation is checked up in ANSYS and transverse rigidity test is simulated .

进一步运用有限元方法，在ANSYS环境下，对受电弓关键零部件的强度、变形等进行了校核，并模拟了 侧向 载荷等 试验；

Huck rivet transverse vibration test rig is designed and developed to adapt mass coercive spot-check of railway truck .

为应对铁路货车铆钉质量强制抽验的要求，设计研制出哈克铆钉 横向振动 试验台。

Effects of carburizing time on microstructure and transverse rupture strength of cemented carbide with gradient cobalt structure fabricated by pre-sintering-carburizing process were studied by optical microscopy and transverse rupture strength test .

采用预烧结-后续渗碳的方法制备钴相呈梯度分布的硬质合金，通过对试样显微组织的观察和 抗弯强度的 测试，研究渗碳时间对梯度硬质合金显微组织和抗弯强度的影响。

In this research the porcine patella to have generated transverse fracture were fixed with three kinds of fixations and regarded as the test samples .

在猪的离体髌骨上模造髌骨 横 形骨折并采用了三种术式固定，作为力学 试样。

The influence of transverse roughness on the pitting of gear tooth surface is discussed in this paper . Research is based on the results of fatigue test for standard gear reducer and stem from the shape of the reversal scallop cave .

本文根据减速器疲劳 试验结果，从倒置贝壳状的蚀坑形貌着手，分析研究了齿面 横向条纹粗糙度对点蚀的影响。

The critical cracking equation as well as the critical preheating temperature of transverse HIC in weld metal can be obtained by G-BOP test .

利用G－BOP 试验方法，得到了临界预热温度和焊缝 横向氢致冷裂纹临界开裂方程。

The data indicate that the first order frequency in the transverse direction is that of this bridge so this direction is chosen for Pseudo-dynamic test .

经分析该桥 横桥向振动的一阶频率为体系的基频，因此选定该方向作为拟动力 实验的加载方向。

In the paper the equations of motion for the vehicle_bridge_MTMD system are presented and the effectiveness of suppressing the transverse vibration of the deck steel plate girder bridge with multiple tuned mass dampers ( MTMD ) is investigated by the field test and simulated calculation .

本文建立了车-桥-MTMD系统振动方程，对利用多重调频质量阻尼器（MTMD）抑制铁路上承钢板梁桥 横向振动的效果进行了模拟计算和现场 试验。

The difference of anchorage properties between the symmetrical and unsymmetrical transverse ribbed rebar was studied considering improving materials ' usage and anchorage properties by pull-out test .

从提高材料使用性能一锚固性能出发采用拉拔 试验研究了 横肋对称和 横肋非对称钢筋的锚固性能的区别。

The frequency composition of velocity for longitudinal test points of structure is mainly low frequency and for transverse test points of structure is mainly high frequency .

位于结构纵向的测点，其纵向速度的频率组成以低频为主；位于结构 横向 的 测点，其速度的频率组成以高频为主。

Furthermore the transverse stress of the hinged joint is analyzed in detail and it is proposed that the adhesive strength between the new and old concrete should be applied to test the transverse stress at the hinged joint .

随后，详细分析了铰缝处混凝土的 横向应力分布规律，并建议应采用新老混凝土之间的粘结强度作为 标准 校核铰缝的横向应力；

Results show that the maximal transverse thermal time calculated with the model agrees well with field test result and the model is of some value for the measurement of sun light thermal difference effect on box girder bridge .

结果表明：由该模式计算出的最大 横向温差时刻与 实测结果十分吻合，对箱梁桥日照温差效应的测试有参考价值。

The inspection and estimate of the thread contour curve were completed by using laser gauge to measure the dimension of the thread contour curve in the transverse section and using raster to measure the axial displacement of the precision worktable under the thread test criterion .

利用激光测量头检测螺纹轮廓在 横截面上的尺寸，结合由光栅测得的精密平台的轴向位移量和螺纹 合格的判断标准完成螺纹轮廓曲线的检测和评价。

The result of numerical simulation for single tube will lead to great error neglecting transverse convection and variable film thickness being lack of experimental test .

数值模拟主要针对单管，数学模型一般忽略 横向对流和膜厚变化，结果缺乏必要的实测 数据 的 验证，直接用于实际机组的设计会带来比较大的误差。

The formulating of recipe of the no asbestos sealing material filled with Aramid fiber was carried out by means of the uniform design method according to the results of the transverse tensile test .

以 拉伸强度为指标，利用均匀设计法对芳纶纤维增强橡胶密封板材进行配方设计，优选得到了理想的配方。

The interface microstructure and mechanical property of the joint were analyzed by SEM EDAX and transverse tensile test .

使用扫描电镜（SEM）、能谱分析（EDAX）和 拉伸 试验对焊接接头界面区显微组织及接头性能进行研究。

Although the two-dimension interface model considered the transverse effects of the matrix and the effects of the material properties on the load transfer ability of the interface Its principle is very complicated and isn 't fit for dealing with the data of the SFC test .

Nairn的二维界面载荷传递模型虽然考虑了基体的 横向效应、纤维／基体材料性能参数对界面载荷传递能力的影响，但是其原理非常复杂，不适合于单纤维复合材料断裂 实验的数据处理。

Investigations were carried out under uniform wall temperature and constant heat flux boundary conditions on heat transfer and frictional characteristics of transverse tube with large roughness for laminar and turbulent flow of oil in a condensation test facility .

在凝结换热 实验台上，采用恒壁温法和恒热流法对油品在大粗糙度 横 肋管中的层流与湍流摩擦阻力与传热特性进行了实验研究。

Get the transverse crack depth median crack length the surface damage layer thickness and cutting parameters of the quantitative relation with the test .

结合 试验 结果得到了 横向裂纹深度、中位裂纹长度、亚表面损伤层厚度与锯切参数的关系。

The forced transverse vibration tests of a ship propeller shafting with a variety of propeller blades were carried out on a test bed .

本文论述了在 试验台上进行的不同叶片数螺旋桨轴系 横向受迫振动实验。