The vitrification point of adhesive with different nano-SiO2 addition was tested by DSC and it was improved by addition of nano-SiO2 particles . The vitrification point of adhesive with 4 % nano-SiO2 addition was 4.23 times larger than unmodified .

利用差示扫描量热仪测试不同纳米SiO2添加量的 玻璃 化 温度，发现 玻璃 化温度随着纳米粒子添加量的增大而提高，添加4%纳米SiO2后的胶粘剂玻璃化温度提高了 4.23倍。

Based on the theory analysis of measured data it is believed that the vitrification point of polytetrafluoroethylene is 100 ℃ approximately ;

基于实测数据的理论分析，认为：聚四氟乙烯材料的 玻璃 化 温度大约为100℃；

A comprehensive research was conducting on the relations among its solidified behavior vitrification point adhesive power impact strength and peel strength .

研究了导电涂层固化行为与 玻璃 化 温度、附着力、冲击强度和剥离强度之间的关系， 确立了导电涂料的最佳固化条件。

The vitrification point is about 182.92 ℃ higher than that of the cellulose or semi cellulose .

DSC的结果说明柿叶的 玻璃 化温度约为 182.92℃左右，高于纤维素和半纤维素。

The curve of the vitrification point ( T_g ) intersects with that of the cloud point at a PPE content ( mass fraction below the same ) of about 60 % ;

玻璃 化转变 温度（Tg）线和浊点曲线在PPE含量约为60%（质量分数，下同）时相交，当PPE含量小于60%时，PPE/TAIC体系的玻璃化温度约为323K；

But as for the hot-filling crystallized bottle it is of great important to assure the sufficient stress discharge at a temperature above the vitrification point for the coming filling operation .

对充气饮料瓶来说，它可抗内压，有好处，但对热灌 装瓶来说就要保证在 玻璃 化温度以上让它充分释放。

The results showed that when heating temperature is near the vitrification point compression speed influences the quality of the parts directly .

结果表明：加热温度在 聚碳酸酯 玻璃 化 温度（ T g）附近时，加压方式直接影响试件的质量；

A Comparison on Cytoplasmic Vitrification and Freezing Point of Chinese Fir and Masson Pine Seeds

杉木、马尾松种子 细胞质冻结和 玻璃 化的比较

The size and distribution of SBR latex particles were determined by laser scattering . The vitrification point and the microstructure of MBS resin were investigated .

研究了SBR粒径大小及其分布、MBS 玻璃 化 转变 温度以及其微观形态。