Vickers hardness tester

[ˈvɪkəz ˈhɑrdnɪs ˈtɛstɚ][ˈvɪkəz ˈhɑ:dnɪs ˈtestə]

维氏硬度计

  • The properties such as corrosion resistance and hardness of the Al-Ni alloy and Al-Mn alloy were detected using electrochemical anodic polarization curve and HV-1000 type Vickers hardness tester .

    采用电化学阳极极化曲线和HV-1000型 显微 维氏 硬度 对Al-Ni合金和Al-Mn合金镀层的耐蚀性和硬度等性能进行了检测。

  • Model HBRVU-187.5 Brinell Rockwell & Vickers Optical Hardness Tester carries a series of rotating testing force and Optical measurement indication system and owns pressure trace measuring device .

    HBRVU-187.5型布洛 光学 硬度 采用了旋转试验力变换机构和光学测量指示系统,在机体上装有压痕测量装置。

  • Precipitation behavior of 7050 aluminium alloy has been studied by transmission electron microscopy and Vickers hardness tester after retrogression and reaging ( RRA ) treatment .

    采用TEM和 维氏 硬度 研究了回归再时效(RRA)处理对7050铝合金的影响,对处理后合金试样的强度和伸长率进行了 测试,并对试样断口在SEM下进行了观察。

  • The microstructure and mechanical properties of Al 2O 3 / TiB 2 composites are studied with optical microscopy SEM and the three point tester and micro Vickers hardness tester .

    利用金相显微镜、SEM、 试验机和 硬度 研究了无 烧结Al2O3/TiB2陶瓷复合材料的组织与性能。

  • By using Spark atomic emission spectrometer Plasma spectroscopy X-ray diffraction Optical microscopy and SEM the changes of composition and microstructure were measured . By using Tensile specimen machine and Vickers hardness tester mechanical properties were measured .

    用火花原子放射光谱仪、等离子体光谱仪、X-Ray衍射仪、金相显微镜、场发射扫描电镜等手段测定了试样成份、显微组织和结构,用拉伸试样机、 维氏 硬度 测定了试样的力学性能。

  • Adjustment on Indentation Position of HVA & 10A Type Vickers Hardness Tester

    HVA&10A型 维氏 硬度 压痕位置的调整

  • The mechanism of brittle-ductile transition influenced by temperature on the single crystal gallium arsenide chip by indentation experiments using vickers hardness tester were analyzed .

    采用 维氏 硬度 对单晶砷化镓片进行压痕实验,分析了温度对单晶砷化镓片脆塑转变机理的影响。

  • The mechanical properties were measured through Vickers hardness tester .

    力学性能测试,采用 硬度 进行检测。

  • The microstructure of functionally graded WC-Co cemented carbide with dual phase structure prepared by so-called two-step technique was observed by metallography . Vickers hardness ( HV2 ) along the gradient was tested by micro-hardness tester .

    用光学显微镜观察了采用两步法工艺制备的双相结构功能梯度WC-Co硬质合金的微观组织结构,并 测量了其小负荷 维氏 硬度

  • Hardness distributions of welded joints are tested on the Vickers Hardness Tester .

    并在 维氏 硬度 上测试了焊接接头的硬度分布。

  • Digitalization principle of Vickers hardness tester

    维氏 硬度 计数 化原理

  • The plasma jet configuration and temperature field were collected by CCD microstructure hardness of the coating were observed or measured by SEM or Vickers hardness tester .

    用CCD数码相机采集了射流的形态和温度场,SX-40扫描电镜观察了涂层的显微组织, HXD-1000A 显微 硬度 测得涂层的硬度。