U-tube heat exchanger

[化] U型管换热器

  • Analysis and Calculation of Vibration of U-Tube Heat Exchanger and Its Countermeasures

    U型 器振动的分析计算及处理对策

  • Failure analysis of tube-to-tubesheet joints of dual-shell U-tube heat exchanger

    双壳程 U型 管子与管板连接失效分析

  • Three kinds of simple heat transfer models of ground source heat pump systems equipped with vertical U-tube ground heat exchanger are introduced . G-function and conduction shape factors are employed to calculate the sidewall temperature of tube-well .

    本文介绍了土壤源 热泵垂直 热器的三种不同简易计算模型,引入不同的导热形状因子,并利用G函数来确定管井井壁的温度。

  • Use of New-Type U-Tube Heat Exchanger in Crude Methanol System

    新型 U 在粗甲醇系统中的应用

  • Failure analysis of U-tube in high pressure heat exchanger

    高压 U 管口开裂分析

  • Based on analytic theory the temperature distributing analytic expression in the ground around the U-tube heat exchanger was obtained .

    基于解析解理论,得出 垂直 周围土壤温度场分布解析表达式。

  • Then it can provide reference for U-tube heat exchanger with self-tight design . Furthermore the paper still compared the overall modeling and local modeling of tube sheet stress analysis .

    为自紧密封U型 的结构设计提供参考。本文对自紧密封 U型 整体建模与局部建模的管板受力进行对比。

  • Discussion on vertical U-tube heat exchanger design for ground-source heat pump systems

    地源热泵系统竖直 U 设计中的问题探讨

  • Design of tubesheet in high pressure U-tube type heat exchanger

    高压 U 管板设计

  • In this paper a full-scale 3D numerical model of a single U-tube ground heat exchanger was built . The effectiveness of the model was verified by comparing the computed results with the field test data .

    本文建立了单 U型 地下 的真实尺寸三维数值模型,通过模拟结果同试验实测数据的对比,验证了模型的正确性。

  • Analysis of the Borehole Resistance in the Vertical U-tube Heat Exchanger

    垂直 U型 埋地 热阻分析

  • This paper analyzed the design methods of the vertical U-tube ground heat exchanger ( VGHE ) based on the line-source model ( LSM ) and cylindrical-source model ( CSM ) .

    介绍了基于线热源理论和柱 热源理论的竖直 U形地埋 器的设计计算方法。

  • In the present work a rarely observed failure mode of dual-shell U-tube heat exchanger was studied and the preliminary reason of the failure was discussed .

    介绍了双壳程 U型 的一种极为少见的失效形式,并对这种失效的原因进行了初步的分析。

  • Research for Craft Equipment of Large-scale U-tube Heat Exchanger

    大型 U 交换 设备工艺装备研制

  • A transient heat transfer model for the simulation of a single vertical U-tube heat exchanger is built and the controlled equation is dispersed in terms of Finite Volume Method . The temperatures of soil and fluid in U-tube are simulated and simulation results and experiment datum are consistent .

    针对垂直 U型 建立瞬态传热模型,采用控制容积法对方程进行离散, 对换 周围土壤温度场和管内流体温度进行数值模拟,模拟结果与实验数据吻合的较好。

  • Numerical Simulation and Analysis of U-tube Ground Heat Exchanger Used in Ground Source Heat Pump ; Numerical Simulation of Vertical U-tube Underground Heat Exchanger for GSHP

    地源热泵U型 地下换热器的数值模拟与分析土壤源热泵垂直 U型 地埋热的数值模拟

  • Research on Mechanical Behavior of Self-Tight Seal Tubesheet for U-Tube Heat Exchanger

    自紧密封 U型 器管板的力学行为研究

  • The design and research of the paper has certain reference value to shell-and-tube heat exchanger especially U-tube heat exchanger engineering design .

    本文的设计与研究对于管壳式换热器尤其是 U 的工程设计具有一定的参考价值。

  • It also represents the material selection fabrication installation and detection of U-tube heat exchanger .

    U 选材、制造、安装和检验等方面进行了阐述;

  • The Study on the Long-Term Cooling of the Vertical U-Tube Ground Heat Exchanger

    垂直 U型土壤 长期供冷问题的研究

  • At the same time there is nobody to do the finite element analysis of U-tube heat exchanger with self-tight seal .

    同时,自紧密封 U型 的整体有限元分析还没有人开展。

  • A description is made of the structural characteristics of the new-type U-tube heat exchanger and an introduction is given to its use in the crude methanol system .

    阐述了新型 U 的结构特点,介绍了该种 在粗甲醇系统中的应用情况。

  • Through stress analysis of tubesheet we can find out the most dangerous operating case and position and then it can provide reference for tubesheet design . Furthermore the paper still studies the self-tight seal tubesheet of U-tube heat exchanger deeply .

    通过对管板的应力分析,找出最危险工况及危险部位,为管板的结构设计提供参考。除了上述工作,本文还深入研究了自紧密封 U型 管板的结构特点。

  • The analysis of cracking failure for U-tube in high pressure heat exchanger was made by means of Chemical composition analysis mechanical properties tests microstructure test SEM analysis of fracture and energy spectrum analysis of corrosion product .

    对高压 U型 泄漏进行了化学成分分析、力学性能测试、显微组织和断口的宏微观分析。

  • An investigation on vibration frequency of U-tube heat exchanger

    U 交换器振动频率的研究

  • Base on several common U-tube heat transfer models of ground source heat pump this paper proposes a transient heat transfer model for single U-tube vertical heat exchanger .

    介绍了几种常见土壤源热泵U型 传热模型,建立了单 U型 垂直 器的非稳态传热模型。

  • Analysis on Leakage Reason of Stainless Steel U-tube Used as Heat Exchanger

    交换器用不锈钢 U型 泄漏原因分析

  • Comparison of Vertical U-Tube Ground Heat Exchanger Thermal Resistance Calculation Methods

    竖直 U 地埋 传热热阻计算方法比较

  • Vertical heat exchanger is mainly divided into single U-tube heat exchanger and double U-tube heat exchanger .

    垂直 U型 换热器主要分为两种:单 U型 和双U型管换热器。

  • GSHP with the adoption of the vertical U-tube heat exchanger has become increasingly popular because of such outstanding advantages as fewer area requirement fewer limits more steady and effective performance etc.

    采用 U型垂直 的土壤源热泵以其占地面积小、适用范围广、性能稳定、 效率高等优势得到了越来越广泛的关注和应用。