uniform deformation

[ˈjunəˌfɔrm ˌdifɔrˈmeʃən][ˈju:nifɔ:m ˌdi:fɔ:ˈmeɪʃən]

均匀形变

  • At the same time difference of temperature field distribution between the sun_slope and the shade_slope will cause non_ uniform deformation of roadbed and cracking on the surface .

    同时,路基阳坡、阴坡两侧地下温度场分布特征的差异构成了路基不 均匀 变形和路面裂缝的潜在威胁。

  • Based on the curve of rheological process it analyses the relation between the initial rheology and uniform rheology . It points out that there must exists the critical uniform rheological deformation of the soft interlayers .

    根据流变过程曲线分析了起始流变与等速流变之间的关系,并指出软弱夹层的临界 等速流变 变形一定存在。

  • The results show : ( 1 ) Deformation of remoulded soil slopes has a stage of uniform deformation which is not clear in structural soil slopes .

    试验结果表明:(1)素土坡经历了明显的 均匀 变形阶段,而结构性土坡的 均匀变形阶段不明显。

  • With increasing pressure the green densification is affected by non uniform deformation and changing inter-powder force .

    随着冷压力的增大,冷压坯中粉末的 变形均匀、粉间摩擦力不断变化,均决定冷压坯的致密化过程。

  • The Euler 's vector and the entire uniform deformation parameters of the blocks with significant relative motion as well as the local heterogeneous deformation within the blocks are derived . The pattern and rate of motion on active boundaries are also calculated .

    求出了有明显相对运动块体的欧拉运动矢量和块体的整体 均匀 变形参数、各块体内部的不均匀局部变形以及活动边界的活动方式和强度。

  • It is practically verified that this method exhibited less expense easy operation cast wall with uniform thickness deformation decrease and cast defects reduction .

    实践证明:该法铸造成本较低、操作简单,且铸件壁厚 均匀变形量小、铸造缺陷较少。

  • The aluminum foams deform from the top to the bottom under explosion load which is different with the uniform deformation under quasi static loading and dynamic loading .

    泡沫铝的波阻抗比较低,泡沫铝在爆炸载荷作用下从上到下发生压缩变形。这与其在准静态和动态情况下泡沫铝 均匀 变形模式不同。

  • The lithosphere of the Tarim basin shows rigid and uniform deformation which enhances the transformation of force .

    塔里木岩石圈呈刚性,且 整体 变形,对应力的传播起到放大的作用。

  • When uniform deformation condition is satisfied superplastic materials will have very high plasticity .

    均匀 变形条件是超塑性材料迭到很高塑性的一个条件。

  • The realization of uniform deformation of tube has great significance to improve surface accuracies of workpiece and strength of the joints by EMF .

    如果能实现 径向 变形沿轴向 均匀 分布的要求,就可以提高电磁成形工件的表面质量及改善管管、管轴电磁连接的强度,对完善电磁成形理论具有重要意义。

  • Influence of Chemical Compositions on Uniform Deformation and Work Hardening Behaviors of Metastable Austenite Stainless Steel Car Body Plates

    化学成分对亚稳态奥氏体不锈钢车体板材 均匀 变形及加工硬化行为的影响

  • Study on uniform deformation control of axial symmetrical H shaped forging

    H形轴对称锻件 变形 均匀性控制的研究

  • The experiments indicate that the metal films under tension are experienced three stages : uniform deformation the microcracks initiation and propagation microcracks saturation .

    研究表明:薄膜/基底结构在拉伸过程中薄膜经历了 均匀 变形、微裂纹形成扩展和微裂纹饱和三个阶段。

  • The meso-deformation during the test process was manifested by uniform deformation .

    剪切过程呈现良好的以 均匀 变形为主的细观变形特点。

  • Uniform deformation and dynamic stress equilibrium in the specimen are guaranteed by means of incident pulse shaping technique during the dynamic loading .

    同时,采用输入波形整形技术,通过调整加载波形,使试样加载过程中保证 均匀 变形及应力平衡。

  • Based on the localized instability theory the limits of the internal pressure were calculated and the UDL ( uniform deformation limitation ) and the concept of LSR ( limited stress ratio ) were proposed to check the basic workability of parts .

    基于集中性失稳理论,计算了胀形压力极限,建立了 均匀 变形极限和极限应力比的概念,形成了零件可成形性的基本判据;

  • Using the combined Rigidity Theory to treat the non - uniform deformation of foundations

    应用联合刚度理论治理基础不 均匀 变形

  • The analysis shows that the high carbon steel wires and low carbon steel wires can have stronger fiber texture 110 w_511 and uniform deformation . So it has a high strength and plastic target .

    研究结果表明,高碳钢丝和低碳钢丝经过辊模拉拔能获得更强烈的〔110〕丝织构, 变形 均匀,具有较高的强度和塑性指标。

  • For i.d 32 mm o. d 42 mm bulging coil and i.d 56 mm o. d 66 mm tube-compression coil the proportion curves of uniform deformation have been obtained and validated by theory and trials .

    对于内径、外径分别为32mm、42mm的胀形线圈和内径、外径分别为56mm、66mm的缩径线圈,得到了 均匀 变形长度比例曲线,并进行了理论和试验验证。

  • Study on Uniform Deformation Control of Forgings

    锻件 变形 均匀性控制的研究

  • A model combining the rigid motion block uniform strain and local deformation is used to describe the present-day activity and deformation of tectonic blocks in China 's continent .

    采用刚体运动+块体 均匀应变+局部 变形的模型作为描述中国大陆构造块体的现今活动和变形的模型。

  • A Study on Uniform Deformation and Necking Velocity of Superplastic Material under the Condition of Uniaxial Tension

    超塑性材料的单向拉伸 均匀 变形和颈缩速度的研究

  • According to the different deformation character of the duplex phase the uniform deformation of dual phase steel divide into three stages .

    根据两相不同的变形特征,把双相钢的 均匀 变形过程分为三个阶段。

  • That the course of uniform plastic deformation before necking was divided into three stages in 290 ℃ .

    在290℃时,颈缩前的 均匀塑性 变形过程分为3个阶段。

  • A new uniform model of free-form deformation is proposed .

    提出一个自由 变形 统一模型。

  • It is shown that deformation of clay has two types one is manifested by uniform deformation the other is manifested by local deformation .

    研究结果表明,上海灰色粘土的变形有两种形式,一是以 均匀变形 为主,二是以局部变形为主。

  • Wide-band scanning makes the temperature distribution more uniform the deformation smaller and the previously treated area affected by the next scan less .

    采用宽带扫描法可使温度分布更 均匀,热处理引起的 变形更小,同时减小下一道对前一道的热影响。

  • An advanced and practical achievement on property design while ensuring the uniform deformation of the heat-treated parts was obtained by means of numerical modeling method .

    在既保证热处理零部件 变形 均匀性又实现性能设计的数值模拟方面取得了处于国际领先的成果。

  • Then it require the cooling process control and deformation control of the spray quenching institutions . This article through the analysis and establishing quenching temperature field and stress field of the finite element model . And studied the influence of parameters on the uniform temperature quenching deformation .

    本文通过分析并建立淬火冷却温度场和应力场有限元模型,研究了各参数对温度 均匀性淬火 变形的影响。

  • The uniform model of free-form deformation is studied .

    研究了自由 变形 统一模型的问题。