vacuum annealing

真空退火[熟炼]

Examples

  • A new soft magnetic alloy with high frequency was prepared by atomized powder molding and vacuum annealing technology .

    鉴于兆频带近场电磁干扰抑制材料需求的增加，采用气雾化制粉、粉末扁平化、绝缘压结、 真空 退火工艺制备出具有高频宽带分布磁导率特性的新型软磁合金复合材料。

  • Heat design of large high vacuum annealing furnace

    大型高 真空 退火炉的热设计

  • Vacuum annealing can repair the damage of crystal lattice and this result in further reduction of film square resistance .

    真空 退火对晶格损伤有修复作用，同时导致薄膜方块电阻进一步降低。

  • Co particles with fcc structure are precipitated from CoCu granular film after vacuum annealing .

    经 真空 退火后，CoCu颗粒膜中析出的Co颗粒呈面心立方结构。

  • Modeling and Control for Vacuum Annealing Furnace Based on Intelligent Method

    基于智能方法的 真空 退火炉建模与控制

  • The accurate control of the work pieces temperature in vacuum annealing furnace is a typical nonlinear large time delay and cross coupling complicated problem .

    而在 真空 退火的生产过程中，退火工件温度的精确控制是一个典型的非线性、大时滞、强耦合的复杂控制问题。

  • The effect of vacuum annealing on the phase and morphology of the vo_x thin films

    真空 退火对VOx薄膜相结构及表面形貌的影响

  • Research and application of intelligent variable structure control method for vacuum annealing furnace

    真空 退火炉智能变结构控制方法的研究与应用

  • Vacuum Annealing of LiF and CaF_2 Thin Films

    真空 退火对LiF和CaF2薄膜结晶性能的影响

  • The development of computer control system of large-sized vacuum annealing furnace for the tube

    大型管材 真空 退火炉计算机监控系统研制测

  • The effect of vacuum annealing was also discussed .

    也讨论了 真空 退火的影响。

  • A study is carried out to determine the radial temperature difference in an existing pit type vacuum annealing furnace and improve the temperature uniformity in it .

    针对径向温差导致同炉 处理的同类产品 力学 性能 的 离散和差异，利用现有的装备条件对井式 真空 退火炉胆内径向温度梯度进行测定，并在提高径向均温性方面进行探索和研究。

  • After vacuum annealing the FeAl ( B_2 ) intermetallic phase forms and dominates in the powder microstructure .

    经进一步 真空 热 处理后，粉末物相转变为以FeAl（B2）为主的金属间化合物。

  • The total deformation is up to 80 % or more before rolling and passing in vacuum annealing the samples can be obtained .

    实验运用 真空 退火 炉，通过采用轧前和道次 退火的方法制备了总变形量达到了80%以上的轧样。

  • SiC nanocrystal ( nc-SiC ) films were prepared on Si ( 111 ) substrates by RF magnetron sputtering and then annealed at 800 ℃ 1 000 ℃ and 1 200 ℃ for 30 min in a vacuum annealing system .

    用射频磁控溅射及后 退火（800℃、1000℃和1200℃）方法，在Si（111）衬底上制备出了SiC纳米晶（ncSiC）薄膜。

  • Study on the Microstructure of VO_x Thin Films Prepared by Vacuum Annealing Method

    真空 退火法制备的VOx薄膜的微观结构研究

  • The optimal temperature of vacuum annealing of deformed alloys and the char-acteristics and mechanism of deformation of biphase W alloys have been discussed in this paper as well .

    本文还讨论了变形合金在 真空下，最佳调质 退火温度和两相钨合金的形变特点、变形机制等。

  • Mechanism Analyses and Optimization of Vacuum Annealing Furnace Model

    真空 退火炉模型的机理分析与优化

  • We also analyzed the effects of processing parameters such as the composition of magnetic layer and under layer the thickness of seed layer and the vacuum annealing on the properties and microstructure of thin films .

    同时，也详细分析了磁性层和底层组分、籽晶层厚度以及 真空 退火对磁记录介质磁性能和微结构的影响。

  • The hydrophilia and surface adsorption states of film modified by ion implantation were mediated by effect of the ion implantation and vacuum annealing collectively and present diversity . 2 .

    离子改性薄膜的亲水性和表面吸附态同时受到离子注入、 退火和氧化钛薄膜的共同影响而表现出多样性变化。

  • The accurate control of the temperature of work pieces is a nonlinear uncertain complicated control problem in vacuum annealing furnace .

    真空 退火炉中工件温度的精确控制是一个具有非线性和不确定性的复杂控制问题。

  • Development of a vacuum annealing furnace for aluminium foil in protective atmosphere ;

    该 模拟 实验机可 模拟带张力试样在 不同保护气氛下的 退火生产过程。

  • The optical and electrical properties of the films will be improved by in-line vacuum annealing and SiO_2 isolate layer between substrate and ATO layer which can improve annealing temperature of the films and lengthen annealing time of the films .

    薄膜的在线 真空 退火 工艺和SiO2隔离层都能提高薄膜的退火温度和延长薄膜的退火时间，能够改善薄膜的光电性能。

  • Design of PLC control system of vacuum annealing furnace for quartz crystal

    基于PLC的石英晶体 真空 退火炉控制系统设计

  • The selection of pickling solution time and temperature are expatiated and the control of heat preservation heating and cooling speed for vacuum annealing are studied .

    阐述了抛光前处理时酸洗液的选择、酸洗温度和时间的控制，以及 真空 退火时升温速度、冷却速度和保温时间的控制；

  • Influence of vacuum annealing treatment on mechanical and tribological property of chromium-doped graphite-like carbon coatings

    真空 退火处理对掺Cr类石墨碳膜力学和摩擦学性能的影响

  • The effect of the different annealing methods on the magnetic properties of DyCo / Cr thin film was researched . We have found that vacuum annealing method is helpful to increase the coercivity of DyCo / Cr thin film .

    研究了不同退火方式对DyCo/Cr薄膜磁性能的影响，发现 真空 退火有利于提高薄膜矫顽力。

  • Modeling and optimization for vacuum annealing furnace

    真空 退火炉的建模与优化