The basic procedure of a multi-input multi-output ( MIMO ) random vibration test is analyzed systematically in the article .

对多输入多输出（MIMO）随机 振动 试验控制的基本过程进行了系统分析。

Application of Ambient Vibration Test and Finite Element Analysis in Health Monitoring of Bridge Structure

脉动 试验和有限元分析在桥梁结构健康监测中的应用

In the paper Aim theory step and result of rolling stock component Sine - Vibration test were introduced .

讲述了机车车辆部件正弦 振动 试验的目的、 法、理、验程序和 试验结果。

Ship Reciprocating Air Compressor Fault Diagnosis Base on Vibration Test and Oil Analysis

振动及油液监测技术在船舶往复式空压机故障诊断中的应用

Huck rivet transverse vibration test rig is designed and developed to adapt mass coercive spot-check of railway truck .

为应对铁路货车铆钉质量强制抽验的要求，设计研制出哈克铆钉横向 振动 试验台。

The means of realization for overloading random vibration test was studied .

研究了过载随机 振动 试验的实现手段。

Application of Vibration Test to Fault Detection of Radar

振动 测试技术在雷达故障检测中的应用

Application of a vibration test system in shock response spectrum test

振动 试验系统在冲击响应谱试验中的应用

Study on the Application of Vibration Test in Solving the Problems of Spot Rotating Member Dynamic Poise

振动 测试在解决现场回转件动平衡中的应用研究

Studies on Damage Identification of Steel Member Structures Based on Vibration Test

基于 振动 测试的杆系钢结构损伤识别研究

Device of shaft alternative torque and torsional vibration test of marine main engine

船舶主机轴系交变扭矩与扭 振 测试装置GB/T3507-1983机械式联轴器公称扭矩系列

Ambient vibration test is the main method of detecting a large bridge structure Modal parameters is important to determine the health status of the bridge .

环境 振动 试验是检测大型桥梁结构的主要方法，检测得到的模态参数是判定桥梁健康状况的重要依据。

Analysis of the effect of vibration technics equipment for rudder-control system vibration test

振动工装对舵系统 振动 试验结果的影响分析

The above-mentioned results are validated through the development of the engine vibration test system .

通过建立发动机 振动 测试系统对上述结论进行验证。

This paper presents a synthesized model updating method using the modal parameters and frequency response functions ( FRF ) extracted from the vibration test data .

文章提出了一种利用模态参数和由 振动 试验数据求得的频响函数来进行模型修正的方法。

Analysis of air flow of the semi-rigid solar array in ground vibration test

半刚性太阳电池阵地面 振动时的空气效应分析太阳电池阵地面展开仿真技术研究与 试验 验证

The vibration test and failure diagnostics are important safeguarding measures during aero-engine tests and component tests .

振动 测试与故障诊断是航空发动机整机和部件试验中的一项重要安全保障工作。

Development of a fault diagnosis system for roller 's vibration test of spinning frame

基于VI的纺纱机罗拉 振动 检测诊断系统的开发

High and low temperature test rig vibration test rig salt spray test rig and pulse pressure test rig are used for automotive A / C products tests .

高低温试验台、 振动 试验台、盐雾试验台以及脉冲压力试验台等为检测汽车空调产品环境性能提供了可靠的保证。

Establishment of the spindle vibration mechanics model and as a basis for design of the spindle vibration test equipment .

建立了锭子振动的力学模型，并以此为依据设计锭子 振动 测试装置。

A two-input two-output random vibration test is performed with a cantilever beam to verify the proposed control method .

以悬臂梁为控制对象，完成了两输入两输出随机 振动 试验。

Comparative Research between Random Vibration Test and Acoustic Test for Small-Satellite

小卫星随机 振动 试验和噪声试验对比研究

Vibration Test Failure Analysis on Engine Plastic Intake Manifold and Improvement Study

发动机塑料进气歧管 振动 试验失效分析与改进研究

Experimental Study on Vibration Test of Subgrade Compaction Degrees

路基压实度的 振动 测试方法试验研究

Based on the broad-band random vibration test on a clamping support in missiles this paper investigates the problems on evaluating the attachment bolt looseness in the structure .

本文在某支撑座结构模型宽带随机 振动 实验的基础上，研究了如何监测连接螺钉组松动故障程度的问题。

Application of a virtual spectrum analysis instrument in loom vibration test

虚拟频谱分析仪在织机 振动 测试中的应用

The results approved the structure design and damping design of air filter and provided theoretical basis for vibration test .

通过分析，证明空气净化器结构设计和 减振设计的 合理性，并为进一步 试验 测试打下理论基础。

Vibration test wind tunnel flutter test and the corresponding calculation are conducted .

风洞 颤振试验和计算 分析。

Torsional Vibration Test of Mechanical System Using Sensorless Detection Method

基于无传感器检测方法的机械系统扭 振 试验研究

Random vibration test simulation for a specimen with vibration-isolating rubber was carried out based on the integrated finite element model of a vibration table a clamping jig and a specimen .

通过建立振动台、夹具和橡胶隔振试件整体有限元模型，对橡胶隔振试件 振动 台随机 振动 试验进行了仿真研究。