A shorter distance between feed plate and taker-in shorter distance between feed plate and taker-in gauge is favorable to remove neps and waste but a longer one will be good to remove seed coat neps .

给棉板与 刺 辊 隔 距愈小，对棉结和杂质去除越为有利，但对带籽屑棉结去除以隔距较大时比较有利。

The fiber length distribution of taker-in droppings and card strips under such conditions as three kinds of pin taker-in and one kind of saw-tooth taker-in at speeds of two doffer and four taker-in level are tested with roller cotton fiber length analyzer .

用罗拉式纤维长度测量仪对3种梳针刺辊和1种锯齿刺辊在二档道夫速度和四档刺辊速度的不同工艺条件下的 刺 辊 落棉 和 盖板 花纤维长度分布进行了检测。

The effect of carding feed plate and taker-in on card sliver quality Size of the coiler trumpet not adjusted to the hank .

梳棉机给棉板与 刺 辊 隔 距对梳棉质量影响圈条器喇叭口的尺寸与 梳棉条的支数不 合适。

This paper discuses the velocity ratio of cylinder to taker-in the roving elongate rate and the fiber loads between cylinder and flat and based on the discussion presents some new opinions on the sub - ject .

本文对锡林 刺 辊间的速比、锡林盖板间的纤维负荷、粗纱伸长率等问题进行了讨论，并提出了若干新见解。

The number and size variation of Neps in card sliver have been explored through experiments under different carding output and speed and by use of different type of taker-in .

实验研究了梳棉机在不同产量、不同速度、不同类型 刺 辊的条件下，生条中棉结的数量和尺寸变化情况。

An Approach to the Relationship between Taker-in Speed Fibre Separation and Index of Sliver

刺 辊速度与生条纤维分离度关系的研讨

Study on fiber length distribution of taker-in droppings and card strips Droppings difference between the saw-toothed taker-in and the gill pin taker-in

梳棉机 刺 辊落棉和 盖板 花纤维长度分布锯齿刺辊与梳针刺 辊 落棉差异的研究

Carding Practice of New Taker-in Wires

一种新型 刺 辊齿条的梳理实践

Investigation of the Relationship between Card Waste Intermittent Suction and Card Sliver Quality Study on fiber length distribution of taker-in droppings and card strips

梳棉 机车 肚间歇吸落棉与生条质量的关系梳棉 机 刺 辊 落棉 和 盖板 花纤维长度分布

Development and Application of the Pinned Taker-in and the Pre-carding Plate

钢针型 刺 辊和预分梳板开发及使用实践

It is believed that if nep number increases during scutching process the taker-in plays a more active role in eliminating the neps while the stationary flat and web purifier do not .

研究认为：清棉过程 中棉结数量增加， 刺 辊对棉结的去除作用很大，后罩板处加固定盖板和棉网清洁器的作用则不大。

Shenyang 's taker-in wire with 75 ° working angle is better that 85 ° wire .

沈阳 刺 辊 锯齿工作角75°优于85°。

So the purpose of studying the action of the taker-in part of the carding machine is to intensify carding and in the same time to abate fiber breakage .

对 刺 辊部分的研究目的在于既加强梳理，又减少梳理过程中纤维断裂。