thick casting

[θɪk ˈkæstɪŋ][θik ˈkæstɪŋ]

[化] 厚壁铸件

  • A silicon based lead zirconate titanate ( PZT ) thick film technology by tape casting is studied in this paper .

    研究了基于 流延 技术制备硅基锆钛酸铅(PZT) 厚膜的工艺。

  • Production of thick section and high strength casting using low alloy cast iron

    利用低合金铸铁生产 高强度 铸件的研究

  • A YSZ film of about 12 μ m thick was deposited on the anode by centrifugal casting and SEM result showed that the film was well adhered to the anode .

    在NiO-YSZ阳极上用离心沉积方法制备了一 12μ mYSZ薄膜,扫描电子显微镜测试结果表明阳极和电解质薄膜之间的接触良好。

  • The technique of centrifugal casting was used . Coating for Centrifugal Casting Pipe The High Purity Aluminium Tube with Large Diameter Spun with Thick Centrifugal Casting Blank

    采用 离心 坯旋压成形大直径高纯铝筒工艺研究

  • The Research on Producing Thick Section Wall Nodular Iron Casting Using Externally Cooling Technique

    采用外冷却生产 断面球铁 铸件的试验研究

  • The successful experience of thick steel plates to replace casting of hydraulic turbine runner lower ring

    水轮机转轮下环由 钢板卷焊替代 铸件的成功经验

  • Study on Simulation of Level Fluctuation in Wide and Thick Slab Continuous Casting Mould with Argon Blowing

    吹氩 宽厚板坯 连铸结晶器内液面波动行为的水模型研究

  • Water Modeling Study on Optimization of Fluid Control Devices in a Wide and Thick Slab Continuous Casting Tundish

    宽厚板坯 连铸中间包内控流结构优化水模实验研究

  • The r value of sample is difference about 0.01 ~ 0.09 between thin slab casting and thick slab casting .

    采用连铸薄板坯轧制的试件r值与常规 厚板坯相比相差 0.02~0.04

  • Research on the Repair Welding of Thick Casting

    关于 铸铁 补焊工艺的研究

  • It is considered that medium thick slab or sheet billet should be adopted for various users ' demands in continuous casting and continuous rolling of hot strip in VAI . It is introduced the characteristic of above technology and production line configuration in VAI .

    VAI公司的热带钢 连铸连轧基于不同考虑分别主张采用中 板坯或者薄板坯,文中介绍了VAI的技术思想的特点和热带钢 连铸连轧生产线配置方案。

  • Research on a method of crack prediction in thick and large casting

    铸件 裂纹预测方法研究

  • Welding of the Big-diameter Thick Casting Steel Pipe

    大口径 钢管焊接

  • Thick - walled Cast Pipe with Small Caliber in Centrifugal Casting

    小口径 壁铸管的离心 铸造

  • The influence of operating condition on Gel tape casting process is studied . The bilayers exhibit superior ME coupling compared to thick film composites prepared by tape casting process .

    讨论了工艺条件对成型的影响。相较于涂敷膜( tape casting)复合样品,该双层膜显示出更为优良的ME耦合效应。

  • The X-way allow a workman in a factory to look into a thick steel casting .

    光可以使 铸造车间的工人看到 铸钢 的内部。

  • It is found that the treatment by electric current or thermal rate changes the morphology of primary iron-rich phase from thick plate-like to flower-like and needle point-like in casting hypereutectic Al-Fe alloys as a result the mechanical property of the alloy is correspondingly improved .

    经电流处理或热速处理后的过共晶 铁合金组织中初生富铁相得到细化,由 粗大的板块状变为花朵状和针点状。由于组织得到细化,力学性能也得到了相应提高。

  • The electric current treatment changes the morphology of primary iron-rich phase from thick plate-like to flower-like and to needle point-like in Al-Fe casting alloys with the increase of electric current density ;

    对熔体进行电流处理,随电流密度的增大,初生Al 3Fe相形貌逐渐由针状转变为花朵状、小针状和针点状;

  • Application of Proportional Solidification to Thick Plate Type Gray Casting

    厚实平板类 灰铁 的均衡凝固工艺