X-ray diffractometry

X射线衍射学

Examples

  • After a subsequent annealing the final crystalline products were preliminarily characterized by X-ray diffractometry and then analytical electron microscopy . High resolution lattice images were recorded by JEOL JEM 200 OX electron microscope .

    用 X 射线 衍射和分析电子显微镜进行研究，并用高分辨电子显微镜观察，由JEOLJEM200CX获得晶格象照片。

  • The binary systems of prazosin hydrochloride and HP - β - CD were characterized by differential scanning calorimetry X-ray diffractometry and Fourier transformation-infrared spectroscopy .

    用差示扫描量热法， X- 射线 衍射和红外光谱对包合物进行物相鉴别。

  • The modern test method of X-ray diffractometry and solid-state CP / MAS ( cross polarization / magic angle spinning ) 13C NMR were used to research naturally colored cotton .

    应用 X 射线 衍射、固体核磁共振（CP/MAS13cNMR）等现代测试手段对彩色棉进行研究。

  • The high-energy impulse degradation of ZnO nonlinear resistors is studied by transmission electronic microscopy in conjunction with X-ray diffractometry and energy dispersive X-ray analysis .

    使用透射电镜、能谱、电子 衍射 等 微观 分析 手段，对脉冲大电流冲击后的ZnO非线性电阻I-V 特性蜕变 现象进行了研究。

  • Determination of solid solution content of FeAl_2 O_4 in MgAl_2O_4 by X-ray diffractometry

    X 射线 衍射法测定FeAl2O4在MgAl2O4中的固溶量

  • Structural analysis of piezoelectric polymer composites-the method of X-ray diffractometry

    高分子复合压电材料的结构分析&X 射线 衍射法

  • Rectorite-nylon sandwich composites with large layer-spacing and lipid materials with long-period ordered structure were studied by small angle X-ray diffractometry .

    对具有大层间距的累托石-尼龙夹层复合材料和具有长周期有序排列的脂质材料等进行了小角度 X 射线 衍射 分析。

  • The thin films of InVO_4 doped by Ni under control were prepared by sol-gel method crystal structure of InVO_4 and the synthesis process were characterized by X-ray diffractometry ( XRD ) differential thermal analysis associated with thermal gravimetric analysis ( TGA-DTA ) .

    采用溶胶凝胶（sol-gel）法制备Ni控制掺杂的InVO4可见光催化剂薄膜。通过 X 射线 衍射分析、差热热重分析确定 InVO4晶体结构及合成工艺；

  • Phase identification is performed by X-ray diffractometry .

    采用 X 射线 衍射确定 薄膜 物相。

  • The changes of granular appearance and crystal structure of starch after being kneaded were investigated by SEM polarization microscope and X-ray diffractometry .

    利用扫描电子显微、偏光显微、 X- 射线 衍射 等 现代 分析 技术，研究了经捏合作用后淀粉颗粒形貌和结晶结构的变化。

  • METHODS : The microscope examination techniques titration methods and X-ray diffractometry methods were used .

    方法：采用显微、 X- 衍射方法进行定性 鉴别，以滴定法测定含量。

  • The structure of BC was measured by the X-ray diffractometry and solid-state CP / MAS 13C-NMR BC have highly crystallinity and cellulose I α / I β .

    通过对细菌纤维素的的 X- 射线 衍射 图谱和固体CP/MAS13C-NMR谱分析，表明细菌纤维素结晶度高，Iα/Iβ比例大。

  • The Analysis of Wood Microfibril Angle by Near Infrared Spectroscopy and X-Ray Diffractometry

    利用近红外光谱和 X 射线 衍射 技术分析木材微纤丝角

  • The formation of inclusion compound was confirmed by the changes of UV spectra solubility taste stability X-ray diffractometry and infrared spectra .

    紫外光谱、溶解性能、味道、稳定性、 X- 射线 衍射 图谱和红外光谱的变化均表明包合物已形成新的 物相。

  • Oxide film was determinated with X-ray diffractometry and scanning electron microscopy exhibited amorphous and ceramic structure .

    用X－ 射线 衍射 分析 法和扫描电镜法检测，氧化膜为非晶态氧化铝陶瓷膜。

  • The effect of nitriding temperature and holding time on formation and grain size of Ti ( C N ) were studied by X-ray diffractometry Electron probe microanalysis ( EPMA ) and micro-image analysis .

    用 X 射线 衍射 仪、电子探针、图像分析仪等研究了碳氮化处理温度及保温时间对Ti（C，N）的形成及其晶粒大小的影响。

  • This paper studied the microstructural characteristics and mechanical properties of self-reinforced high density polyethylene ( HDPE ) rods with scanning electron microscopy wide angle X-ray diffractometry differential scanning calorimetry and mechanical analysis .

    通过扫描电子显微镜、差示扫描量热法、广角 X 射线 衍射 分析与力学性能 测试，研究了自增强高密度聚乙烯（HDPE）棒材微观结构特点和力学性能。

  • The effects of the initial calcium / phosphorus molar ratio and the pH of the solution on the microstructure and phase composition of the powders were studied by scanning electron microscopy ( SEM ) and X-ray diffractometry ( XRD ) .

    通过扫描电子显微镜（SEM）和 X 射线 衍射 分析（XRD）研究了 配料的Ca/P物质的量比和溶液的pH值对粉体显微结构和相组成的影响。

  • The result was confirmed furthermore by high resolution X-ray diffractometry .

    利用高分辨 X 射线 衍射 仪进一步验证了这一结果。

  • The inclusion effect between SDC and β - cyclodextrin (β - CD ) was studied by differential thermal analysis ( DTA ) and X-ray diffractometry .

    SDC和β-环糊精（β-CD）之间的包合作用采用差示热分析法和 X- 衍射 法进行 验证。

  • The phase composition and microstructure feature of samples austempered with different processes were studied by X-ray diffractometry ( XRD ) optical microscopy ( OM ) and transmission electron microscopy ( TEM ) . Tensile notched impact and wear resistant properties were measured .

    采用 X 射线 衍射 仪（XRD）、光学显微镜（OM）和透射电镜（TEM）研究了不同工艺的低温等温转变处理试样的相组成和组织特征，并测定了拉伸、缺口冲击和耐磨性能。

  • The effects of different nucleating agents on the crystallization behavior and the properties of Li_2O-ZnO-SiO_2 glasses were investigated by means of differential thermal analysis X-ray diffractometry Fourier infrared absorption spectrometry and scanning electron microscopy .

    采用差热分析、 X 射线 衍射及傅里叶红外吸收光谱 等 测试手段，分析不同晶核剂对Li2O-ZnO-SiO2系统玻璃析晶行为和性能的影响。

  • A kaolinite / benzamide intercalation compound was prepared by melting intercalation method using a kaolinite / dimetyl sulfoxide intercalation compound as an intermediate . The product was characterized by powder X-ray diffractometry and Fourier transformed infrared spectroscopy .

    以高岭石/二甲亚砜作为前驱物，用熔融插层法成功制备了高岭石/苯甲酰胺插层复合物，产物用 X 射线 粉晶 衍射和Fourier变换红外光谱进行了表征。

  • Investigation on the Spontaneous Strain and Ferroelastic Domain Structures in NdP_5O_ ( 14 ) Crystals by High Resolution X-ray Diffractometry

    高分辨 X 射线 衍射 术对NdP5O（14）晶体的自发应变及铁弹畴结构的研究

  • The microstructures and phase characteristics of six kinds of TiAl binary alloys with different Al contents have been studied using metallography scanning electron microscopy and X-ray diffractometry .

    用金相、扫描电镜和 X 射线 衍射研究了6种不同Al含量Ti-Al二元合金铸态和 退火 态的组织结构和相 组成的特征和 变化。

  • It is found that the crystallization temperature of the composite coating decreases from the results of X-ray diffractometry and differential scanning calorimetry .

    X 射线 衍射 分析 （ XRD）和差示扫描量热分析（DSC）结果表明， 粒子没有 改变复合镀层镀 态结构 （非晶态），但使得复合镀层晶化温度降低。

  • X-ray diffractometry of the structure of in_xga_ ( 1-x ) as / gaas superlattice

    InxGa（1-x）As/GaAs超晶格的 X 射线 衍射 研究

  • The influence of process parameters on the microstructure and corrosion-resistance of Pd-Co alloy was studied by X-ray diffractometry and potentiodynamic polarization techniques .

    利用 X 射线 衍射 分析和动电位扫描技术 等 测试 手段，考察电沉积工艺条件对Pd-Co合金镀层微观相结构和耐蚀性的影响。

  • Microstructure characteristics and microhardness in the diffusion bonded TiC-Al_2O_3 / W18Cr4V joint were investigated by means of scanning electron microscope X-ray diffractometry and electron probe microanalysis .

    采用扫描电镜、 X 射线 衍射、电子探针 等 测试方法分析了TiC-Al2O3/W18Cr4V扩散连接接头的微观组织结构和显微硬度分布。

  • Study on sandwich composites and large spacing organic macromolecule materials by small angle X-ray diffractometry

    小角度 X 射线 衍射 法研究夹层复合材料和长程有机大分子材料