The Selection of Cathode Protection Method on Crude Tank Bottom Plate and Parameters Calculation

原油 储罐 外 底板阴极保护方式的选择及参数计算

On Arrangement of Inner Tank Bottom Plates and Annular Plates of LNG Low Temperature Storage Tank

LNG低温储罐内 罐 底板与环板排板的探讨 炉底 砌体温度记录仪

Based on the heat fluid energy equation and the cathodic protection mathematics model controlling equation the tank bottom cathodic protection mathematics model of the deepwell anode is established .

根据热流体能量方程和阴极保护数学模型控制方程的相似性，建立了深井阳极对 储罐 底板阴极保护体系的数学模型。

The experiment result can be a reference of corrosion acoustic emission detection for actual tank bottom .

该实验结论对实际的 罐 底腐蚀声发射检测有一定的借鉴价值。

In this paper the problem of nonlinear coupling vibration for a liquid storage tank bottom of which is uplifted under the action of horizontal or vertical excitation is studied by experiment on the vibration table .

通过储液 罐 模型在水平和竖向振动台上的提离振动实验，对 罐 底与基础接触边界移动的 储 液 罐非线性耦联振动问题进行了研究。

After analyzing the reason of bottom deformation and the geometry form of tank bottom the movement model of bottom deformation was established the calculation formula was derived and the numbers and installation sites of level sensors were confirmed .

新方法分析了 立式 罐底部几何形状和产生变形的原因，建立了 罐 底部变化模型，推导出了底部变形量的计算公式，确定了液位传感器的数目和安装地点。

Explicating corrosion reasons and types of oil storage tank in oil refinery plant it introduces corrosion situation at oil storage tank bottom and wall and analyzes mechanism of the corrosion .

论述了炼油厂储油罐腐蚀的原因、类型，介绍了 油罐 罐 底 和 罐壁的腐蚀情况，分析了 储油 罐腐蚀的机理。

The external corrosion mainly covers the corrosion on tank top head tank bottom plates and wall plates .

外腐蚀主要包括罐顶、 罐 底板和外壁的腐蚀。

Study on Pollution-free Treatment of Oily Sludge from Tank Bottom by Microorganisms

微生物对 储油 罐 底油泥无公害处理初步研究

Taking 160 m3 LNG tank as a research object it makes heat leak calculation on tank bottom top and wall respectively and reckons the allowable heat leak according to the tank daily evaporation rate .

以一个16万立方米的LNG储罐为研究对象对 储罐 罐 底、 罐顶和 罐壁分别进行了漏热计算，根据日蒸发率计算了储罐的许用漏热量。

By comparing the method can eliminate the effect resulted from tank bottom deformation and improve the measurement precision .

经比较，此方法能减少 立式 罐 计量受 罐 底变形的影响，提高了 立式 罐计量的精度。

Compared with the sum heat leakage of tank bottom top and wall it makes an analysis on the insulation performance of the tank .

将 储罐 许用漏热量与 罐 底、 罐顶和 罐壁的漏热量之和进行比较后，对储罐的保冷性能做出分析。

Study on the Application of SD Tank Bottom Valve in Stilt Pipe Settling Tank of Brine

SD 池 底阀在卤水斜管沉淀池中的应用研究

A mathematical model was established for the cathodic protection potential distribution outside of tank bottom in which the inhomogeneity of medium was taken into account .

建立了 罐 底外侧阴极保护电位分布的数学模型，模型中考虑了介质的不均匀性。

Application of Bubbling From Tank Bottom to Float Glass Production in our Company

池 底鼓泡在我公司浮法玻璃生产中的应用

The Research of Uncertainty in Real-Time Measurement System of the Vertical Metal Tank Bottom Increment

立式金属 罐 底量增量实时测量系统及不确定度分析

A new approach of impressed current cathodic protection for external tank bottom has been developed .

本文提出了钢质 贮 油罐外 底阴极保护的一个新方案。

Carried out static and dynamic mechanical analysis on typical dangerous location of tank bottom and side when the robot is working proposed magnetic control program and established kinematics and dynamics models of wall-climbing robot . 3 .

针对机器人在 罐体 底 面及侧面典型危险位置进行了静力学和动力学分析，提出了磁力控制方案和差速转向控制方式，并建立了爬壁机器人的运动学模型和动力学模型。

When water temperature higher than the tank bottom water collector top of several degrees water temperature control device will start water make the water flow .

当收集器顶端水温高于 储 水箱 底部水温若干度时，控制装置将启动水使水流动。

Stainless steel tanks do not need to be regularly cleaned the water sediment on a regular basis just to open the sewage tank bottom valve can be discharged .

不锈钢罐无需经常清洗，只需定期打开 罐 底的排污阀便可排出水中的沉淀物质。

Calculation methods to determine the mass of polygonal and non-regular form steel plate are introduced and a principal block diagram for oil tank bottom plate mass calculation is listed in this paper .

介绍了多边形钢板与不规则多边形钢板质量的计算方法，列出了用计算机计算 油罐 底板质量的原理框图。

Inspection Techniques and Cathodic Protection for Crude Oil Tank Bottom Plates

原油 储罐 底板的检测技术及阴极保护

Because of more complicated structure the welding sequence of buoyancy module roof is very different from that of tank bottom board .

由于浮舱顶结构较复杂，其焊接顺序与 罐 底 幅板的焊接顺序有较大差别的。

Leakage Simulation Test and Calculation of Seepage Quantity of Oil Tank Bottom Plate

油罐 罐 底渗漏模拟试验及渗漏量计算

Installation Technique of Grid Anodes of Cathodic Protection for Storage Tank Bottom Plates

储罐 底板阴极保护中网状阳极的安装技术

This text through is it set up fuzzy matter element of model of appraising to build deposit to oil tank bottom liquid is it is it appraise to corrode to go on mainly .

本文主要通过建立模糊物元评价模型，对 油罐 底部沉积液进行了腐蚀评价。

Magnetic Flux Leakage Testing of Corrosion in a 5000 m ~ 3 Paraffin Oil Tank Bottom and Its Integrity Evaluation

5000m~3蜡油 储罐 底板的漏磁检测与完整性评定 油罐剩油量高度的测定

Study on Submerge Arc Welding of Large-scale Storage Tank Bottom Plate

大型储罐 罐 底板埋弧自动焊施工工艺研究

The wastewater of the oil depot is generated from oil tank bottom water bilge water tank cleaning water living water and the rain .

油库库区产生的污水包括 油罐 底水、清洗油罐水、压舱底水、洗舱排水、生活用水以及雨水等。

On the basis of bottom structure of oil tank widely used in home a 12-m-diameter simulated tank bottom plate and corresponding impressed current cathodic protection system are established .

根据国内普遍采用的罐底结构，建立了一个直径为12m的模拟 罐 底板和相应的外加电流阴极保护系统。