Trigger circuit power supply circuit clocking circuit and reset circuit are the main circuits on the main board .

触发 电路、供电电路、时钟电路、复位电路是主板上最主要的电路。

In the software about the realization of control algorithm and the Phase-shifting Trigger Circuit are discussed detailedly .

软件中还对对控制算法和 移相 控制 电路描述程序的设计进行了具体的论述。

Trigger circuit have a certain width and pulse signals control thyristor conduction .

触发 电路产生一定和宽度的脉冲信号，控制闸流管的导通。

Appliance of TC787 ( AP ) in the Soft Starter Trigger Circuit

TC787（AP）在软起动器 触发 电路中的应用

Data acquisition and trigger circuit design .

数据采集和 触发 功能的设计。

Trigger circuit structure is simple flexible control temperature control accuracy can be compensated by software can adjust arbitrarily limits have won the wide recognition .

触发 电路结构简单，控制灵活，温度影响小，控制精度可通过软件补偿，移相范围可任意调节等特点，目前已获得业界的广泛认可。

Improvement of Synchronizing Signal of Thyristor Trigger Circuit

对晶闸管 触发 电路中同步信号的改进

Designed trigger circuit based on CPLD in this paper .

本文基于CPLD设计了 触发 电路。

Steady-state electromagnetic hit single integrated circuit trigger circuit and MOSFET .

电磁击打电路采用单稳态集成 触发 电路和MOSFET设计。

This paper develops a three-phase SCR trigger circuit adopting the cur-rent integrated circuit .

采用通用集成电路设计了一种三相可控硅 触发 电路。

The developed trigger circuit can produce a reliable trigger signal at either polar of the input pulse signal .

设计的 触发 电路对输入的任何极性脉冲都能产生可靠的触发信号；

A trigger circuit is designed to control laser output by computer .

设计了激光 触发控制 电路，由微机发送 指令控制激光触发；

The trigger circuit products the pulses to trigger the thyristors with the control outputs ;

触发 电路根据控制信号输出的控制信号产生相应触发 角的晶闸管触发脉冲；

So this dissertation realized a kind of high efficiency charge and trigger circuit which can be widely meet the varied requirements of photography by hardware .

因此本设计从硬件上实现了一种高效的闪光灯充电和 激发 电路，可以广泛满足各类摄影要求。

The Design of Thyristor Trigger Circuit for Temperature Control System in Rapid Sintering Equipment

快速烧结设备温控系统中晶闸管 触发 电路设计 发射极耦合 触发 电路

It is perfect phase trigger circuit for arc welding power source of SCR .

该相 控 触发 电路是晶闸管整流弧焊电源的理想 触发 电路。

Low jitter trigger circuit and wide band amplifier of fast electronics

快电子学低晃动 触发 电路和宽带放大器的研究与分析

Signal condition circuit A / D circuit time-base circuit and trigger circuit are discussed .

硬件设计方面，本文主要讨论了信号调理电路、A/D变换电路、时基电路及 触发 电路 的 设计等。

In the other hand the trigger circuit driver circuit and control circuit of MOSFET switches were also studied .

二是研究 MOSFET开关管的 触发、驱动和控制等相关技术。

The switch circuit is composed of an emitter-coupled trigger circuit an integral delay circuit and a monostable circuit .

其中开关电路由射极耦合 触发 电器、积分延时电路、单稳态电路三单元构成。

A novel trigger circuit of signal sampling for modularized high-resolution compact gamma camera

高分辨小型伽玛相机的数据采集 触发 电路

Implementation of Trigger Circuit in Digital Storage Oscilloscope by FPGA

数字存储示波器中 触发 电路的FPGA设计与实现

The circuit of controlling data acquisition and the trigger circuit of SCR are described in detail .

详细阐述了控制的数据采集和可控硅 触发 电路。

Practice has proved this circuit is a good SCR trigger circuit .

实践证明该 触发电路是一个性能良好的可控硅 数字 触发 脉冲 产生 电路。

The application of PWM electronic commutator to be controlled by 8098 singlechip microcomputer to brushless DC motor drive system was introduced with focus on the trigger circuit and drive circuit of IGBT converter .

介绍了8098单片机控制的脉宽调制（PWM）电子换向器在无刷直流电机调速系统中的应用。主要介绍了绝缘门双极晶体管（IGBT）逆变器的 触发 电路和驱动电路。

The external control trigger circuit is designed .

设计了外部控制 触发 电路；

A full digitized construction of the trigger circuit used in digital storage oscilloscope is discussed .

提出了一种全数字化的数字存储示波器用的 触发 电路结构。

Power Braking Trigger Circuit Study Based on Single Chip

基于单片机的动力制动装置 触发 电路研究

The CMOS Schmitt trigger circuit with low voltage by the dynamic body-bias technology was presented .

提出了一种利用MOS管的体偏置技术实现的低电压施密特 触发器 电路。

CPLD chip is used to simply realize the efficient control for the trigger circuit of HF-link inverter power and a design method of trigger circuit on the basis of CPLD is proposed .

采用CPLD芯片以简单可行的方法实现了对高频链逆变电源 驱动 电路的有效控制，介绍了基于CPLD的大功率航空逆变电源的设计原理和设计方法。