The quality of the stainless steel surfacing welding on the tubeplate is very important to the heat exchanger manufacturing .

因此， 管 板不锈钢堆焊质量是整个换热器制造的关键。

This article introduced the experiment of residual stress in flat tubeplate head of large scale fuel boiler that was manufactured by cold rotary extruding and butt weld .

本文介绍了大型燃油锅炉经拼 板焊接和冷旋压加工制造而成的平 管 板 封头残余应力试验。

Strength Calculation of Thin Tubeplate Heat Exchanger

薄 管 板强度计算 公式 的 选用 及简化

Four correction measures are put forward to avoid tubeplate joints corrosion cracking for the titanium reboiler .

提出了避免钛制再沸器 管 板接头腐蚀开裂的4项措施。

Preference is discussed for the suitable Strength calculation formula of the thin tubeplate in fixed tubesheets of heat exchangers and a feasible method is given .

讨论固定管板式薄管权换热器设计中薄 管 板强度计算公式的选用，并对其进行适当的 简化，提出一种切实可行的计算方法。

Overhaul of fixed tubeplate heat exchanger expansion joint

固定 管 板换热器膨胀节的修复

After building a boiler with fillet weld connecting furnace tube and tubeplate the practical stress and temperature measurements have been carryed out near the weld on the boiler .

制造了炉胆与管 板连接为角焊缝结构的锅炉，对锅炉角焊缝区域进行了实际工况应力测试与温度测试。

Dissimilar Metal Tube to Tubeplate All Position Welding by Automatic Tungsten Arc Welding Procedure

异种钢 小 直径 管 与 管 板的全位置自动钨极氩弧焊

Reasons for Tubeplate Joint Welds Corrosion Cracking of Titanium Reboiler and Correction Measures

钛制再沸器 管 板接头焊缝腐蚀开裂的原因及改进措施

The traditional expansion joint method between tube and tubeplate of heat exchanger is mechanical expansion joint which has many undefined factors and defects especially when it is applied to chemical equipment used in corrosive environment and joint tubes which are difficult to approach .

换热器管与 管 板的传统胀接方法是机械胀接，它有许多不确定的因素和缺点，特别是应用在具有腐蚀性场合的化工设备和在不易接近的管胀 接工作中。

Modeling Research on convex die forging of tubeplate with directional solidified ingot by means of high temperature moire method

定向凝固锭 管 板凸砧锻造工艺高温云纹法模拟研究

Study on the Characteristics of Explosive Joint of Tube / Tubeplate

低压 加热器爆炸胀管特性研究

Numeric Controlled Processing of air Preheater Tubeplate

空气预热器 管 板的数控加工

The program handle of intensity of boiler 's tubeplate

锅炉 管 板强度的程序处理

Development of Baffler-Type Water Cooler with Thin Tubeplate

折流杆式薄 管 板水冷却器的开发

Examples of tubeplate stress analysis with ANSYS

应用ANSYS分析 管 板应力实例