tube wall

[tub wɔl][tju:b wɔ:l]

管壁

  • Inside the plug is placed a moving tube which has a catch on top a medicine port a notch in the tube wall and a positive stop bulkhead at bottom and cooperates with the sling tube .

    瓶塞顶口内插入顶端为动管拉手、下设动 出药口、动 槽口和动管限位挡板且与吊管动配合的动管。

  • There are pile of partial electric charges at the tube wall .

    上还存在局部电荷的堆积。

  • The greater the steel tube wall thickness the higher the limit loading capacity of expansive concrete filled square steel tube is .

    钢管 厚度越大,方钢管膨胀混凝土极限承载力越大。

  • The principle and method of nondestructive inspection on tube wall thickness and defect using compton scattering are described .

    介绍了利用康普顿散射对 厚度和缺陷进行无损检测的基本原理和方法。

  • By discussing the calculations of Max. metal temperature at tube wall of tubular heaters formula intention are evaluated .

    从讨论管式加热炉最高 金属温度的计算公式开始,分析评述了公式的内涵;

  • Underground oil tube wall is a special high temperature high pressure and strong reverberation channel which makes ultrasonic communication system demanding .

    井下 油管 是一个特殊的、高温高压及强混响的信道,对超声波通信系统提出了苛刻的要求。

  • The factors that influenced the analytical results of lead by probe atomization AAS were studied and analytical performances of the method were compared with those by tube wall atomization AAS .

    通过实验,确定了最佳的仪器条件和探针原子化分析条件,并与 原子化法进行了比较。

  • The Numerical Simulation Calculation for Tube Wall Temperature of Pedant Superheater of Power Station Boiler ; Fuel Heater Temperature Sensor and Element Location

    大型电站锅炉屏式 过热器 温数值模拟燃油加热器温度感知器和元件的位置

  • Tube wall temperature decreasing and operation consumption reducing brought remarkable benefit .

    降低了 温度和运行消耗,效益显著。

  • The Heated Tube Overheating Problem of Superheater and Reheater in High Parameter Large Capacity Utility Boilers and Tube Wall Temperature Online Monitor

    高参数大容量电站锅炉过热器再热器的超温问题和 内壁温在线监测

  • The tank tube wall construction of climate laboratory is adopted with the somersaulting formwork technology and the no scaffold technology .

    环境气候实验室罐体 施工采用翻模施工技术和无脚手架施工技术。

  • Analysis and Treatment of Temperature Deviation of High Temperature Superheater Tube Wall of 410t / h Boiler

    410t/h锅炉高温过热器 温度偏差的分析处理

  • Based on the process simulation and the analysis method of thermal power system the tube wall metal temperature online monitoring system of high temperature heating surface was successfully developed .

    在借鉴过程仿真和热力系统分析方法的基础上,开发了一 锅炉高温受热面金属 温在线监测系统。

  • The pressure in tube wall is higher than that in tube center .

    压力波的压力大于爆震管道中间压力。

  • This battery-like reaction produces and electrical charge that leads to the striations within the tube wall .

    这个像是电池产生电荷反应般,进而导致在 内留下条纹状(裂痕)。

  • Data processing and error analysis for tube wall flaw test

    管材 内壁缺陷检验数据处理和误差分析

  • The tube wall thickness distribution and the energy parameters were analyzed on the basis of simulation results .

    基于计算结果,分析了 厚分布规律、机架力能参数分布。

  • The effect of the content of expansive additive and steel tube wall thickness on the mechanical properties of expansive concrete filled square steel tube were studied .

    实验研究了膨胀剂掺量和 钢管 厚度对不同强度等级方钢管膨胀混凝土力学性能的影响。

  • The practice shows that the hydrodynamic performance in the water-wall is stable and the tube wall temperature of the heating surface is normal during intermittent pressure cycle purging with flame .

    不熄火降压吹管时锅炉水冷壁水动力工况稳定,受热面 不超温,其成功经验可为类似锅炉吹管提供参考。

  • Study on the Prediction of Tube Wall Thickness Based on Neural Network

    基于人工神经网络的 钢管 厚预测研究

  • An improved method for computing temperature of the tube wall of superheater and reheater in boiler is introduced .

    对电站锅炉对流过热器和再热器的 温计算方法进行了改进。

  • The heat rejection efficiency of the fin is decreased with the temperature of tube wall decreasing and the necessity of fitting fin is reduced when the wall temperature is higher .

    肋片的散热效率随 温度的升高而减小,壁温较高时安装肋片的必要性降低。

  • It is well known that it is rather difficult to suppress a big number of forming holes on the separator 's tube wall due to its complicated dimension .

    分离器 压制大量成型孔,外形、尺寸位置要求复杂,定位困难。

  • Study on a Model of Real Fluid Flow Having Heat Loss on Tube Wall

    存在 换热损失的真实流体流动模型的研究

  • When tube wall strength can not bear inner steam pressure in the tube blowout of low-temperature tube occurs .

    强度无法承受管内蒸汽压力时,导致低温过热器管爆裂。

  • High Frequency Supersonic System for Measuring Thickness of Metal and Oxide-Scale on Tube Wall

    金属层和氧化皮厚度高频超声波测量系统的建立

  • For irregularly hot stress acting tube curve it stressfully analyzes effect of body tube wall thickness difference .

    对于不规则热应力作用下的身管弯曲重点分析了身 厚差的作用。

  • The numerical study aims at obtaining a calculation method of flame tube wall temperature .

    计算研究目的是摸索一种火焰 温的计算方法,以较好地获得火焰 温分布。