The Study on the Tuning Fork Vibration and the Time Difference Detection of the Confocal Probe

共焦 测 头中音叉 振动与时间差检测问题的研究

Low Frequency Vibration Measurement System of MEMS 3D Micro Tactile Probe

MEMS三维微触觉 测 头的低频 振动测试系统

The Horizontal Vibration Problems of Railway Bridge and the Investigation & Probe in the Comprehensive Cure of Chuhe Railway Bridge Around Nanjing for Jinhu-railway

京沪铁路南京段桥梁横向 振动问题和 滁河特大桥综合整治探索

The influence of external vibration on scanned images of scanning probe microscope ( SPM ) is discussed .

探讨了外界 激 振对扫描 探针显微镜（SPM）扫描图像的影响。

The theory of vibration measurement by interference with a multimode single optic fiber probe and an experimental arrangement as well as the experimental results are presented .

本文介绍了单根多模先纤 探头的干涉 测振实验装置，测量原理以及实 探结果。

Vibration is an important research topic in the field of scanning probe microscopy .

振动是扫描 探针显微术中的重要研究课题。

Localization Design of 8mm Electric Eddy Displacement / Vibration Sensing Probe

8mm电涡流位移/ 振动传感器 探头的国产化设计

In this system The vibration of microprobe is detected using the combination of DMT ( Derjaguin-Muller-Toporov ) model and light probe point-diffraction theory .

该系统利用DMT模型来分析微探针与样品间的作用力；同时利用光 探针点衍射理论构造系统中的微位移传感器，来检测微探针的 振动；

The theoretical equality of optical beat frequency and traditional interference phenomenon is performed the result can be applied to varing beat frequency as well as to constant beat frequency which provid a theoretical basis for detection of vibration using heterodyne laser probe .

从而在理论上统一了光拍频与传统的干涉现象，这一结果对拍频为常量与拍频随时间变化两种情况均适用，由此可以给出用外差激光 探针测 振动的理论依据。

A likely solution to this problem where specimen vibration is present is to recess the probe into a hard-rubber sheath .

当试样发生 振动时，合适的解决方法是把 探头放进一个硬橡皮护套里。

The biquadrate vibration equation for fork-probe-sample system is established the relations between the electric current of the fork and T-S distance ( I-d curves ) are analysed theoretically and the mechanism model of the shear force between the optic fiber probe and the sample is established .

研究了石英调谐音叉控制T-S间剪切力作用的机制，建立了音叉T-S系统的 振动方程，理论分析了 音叉电流I和T-S间距d的关系，建立了T-S间剪切力作用机制模型。

This dissertation makes a study on the stability of the tuning fork vibration and the accuracy of the time difference detection of the confocal probe based on the time difference measurement .

本文针对时间差法共焦 测 头中的音叉 振动稳定性与时间差检测准确性的问题进行了研究。

General Narration to the Development of Vibration Screening Machinery and Primary Probe to New Type Vibration Screen

振动筛分机械发展概述及新型振动筛研究 初探

By using dedicated circuitry and sensor it can get the viscosity of the fluid through the signal from the FBG and the vibration amplitude of the probe .

采用专用电路系统及传感模块，通过检测FBG光纤光栅中的信号来得到 测 头 的 振动幅度，从而推算流体黏度。

The early fracture of base cylinder for motorcycle vibration absorber was analyzed by electron probe microanalyzer ( EPMA ) and optical microscope .

采用光学显微镜和电子 探针分析仪等分析手段，对ZL107铝合金摩托车 减震器底筒的早期断裂进行了分析。

To analyze the influence of external vibration on the tip-sample interaction of scanning probe microscope ( SPM ) a concept vibration rejection ratio ( VRR ) was proposed .

为分析外界 振动对扫描 探针显微镜（SPM）针尖-样品副的影响，提出抑振系数的概念。

The Theory and Experiment of Vibration Measurement by Interference with a Multimode Single Optic Fiber Probe

单根多模光纤 探头的干涉 测振原理及实验